资源列表
spi_loopback
- DSP的SPI工作模式，该模式是采用的查询方式。先要设计主从方式。然后就可以进行数据传输。
shiboqi.rar
- 用msp430自带的ad制作的简易示波器，方波能到1200hz，正弦波能到300hz，P6.0口接前级偏置与隔离电路,Msp430 comes with a simple ad produced oscilloscope, a square wave to go to 1200hz, sine wave to go to 300hz, P6.0 I take pre-class bias and isolation circuit
wince-web-server-handler
- 利用GoAhead构建嵌入式web应用。在wince环境下的handler程序。-/* * handler.c-- URL handler support * * Copyright (c) GoAhead Software Inc., 1995-2000. All Rights Reserved. * * See the file "license.txt" for usage and redistribution license requirements * *
leddianliang
- 在8X8点阵式LED显示“★”、“●”和心形图，通过按键来选择要显示的图形。-暂无
F912_SleepMode_PortMatchWake
- Silabs C8051F9xx 低功耗设计-Silabs C8051F9xx low power design
2410linux-to-drive-8255
- 这是在linux下编写的基于LJD2410开发板驱动8255的驱动程序和测试程序，程序中有完整的注释，并且附带实验说明和Makefile文件，作者使用的事蓝海微芯ARM9/LJD2410I开发板。-Some drive code and application code for ARM9/2410 to using 8255, also the makefile and instruction file.
drusrc
- 通过arm下载fpga程序。已经成功通过测试-Download fpga program through the arm. Has been successfully tested
AT90CAN128_0322
- 单片机AT90CAN128，CAN总线接口例程，为刚开始应用CAN接口的开发人员提供帮助。-microprocessor AT90CAN128 , CAN bus interface program, to provide help for the first CAN interface application developers.
Stepper-motor
- 基于单片机的步进电机控制，开发环境keil-Microcontroller based stepper motor control
4.7_watchdog_test
- void Main(void) { sys_init() // Initial 44B0X s Interrupt,Port and UART wdtimer_test() // test start }-void Main (void) (sys_init () / / Initial 44 B0X's Interrupt. Port and UART wdtimer_test () / / start
GUIDEMO
- modify ucgui graph.c demo plus wave, it is very wonderful
common
- UART common functions