资源列表
LCD12864A_430
- 基于MSP430F22X4系列的液晶显示器12864的驱动程序
ds12c887
- 本文件为时间芯片ds12c887的驱动程序
bomb
- source code for microchip 8 bit architecture microcontroller, created for a general pourpose timer/clock with 7 segment display, it use 2 internal timer interrupts. Build with CCS C compiler.
xiaochedaima
- 介绍一种基于红外光电传感器的智能车自动控制器设计方案。以飞思卡尔16 位单片机为核心控制单元，使用红外光电传感器采集路径信息，控制智能车的舵机、驱动电机，实现智能车的自主寻迹行驶。-Introduction of a photoelectric sensor based on infrared automatic controller for intelligent vehicle design. Based on Freescale 16-bit microcontroller as the
asem18061
- Please read your package and describe it at least 40 bytes in English. System will automatically delete the directory of debug and release, so please do not put files on these two directory.
Taximeter-VHDL
- 使用硬件描述语言编写的一段出租车计价程序，对里程、计价、等待计价做出统计和显示-Written using a hardware descr iption language Taximeter procedures, mileage, pricing, waiting to make pricing and display statistics
Tetris
- 俄罗斯方块源代码，使用的是LPC2103-Tetris source code, using the LPC2103
balance_car_base_on_arduino
- 基于arduino的自主两轮平衡小车，这是自己自主学习实验过程的结晶，采用mpu6050姿态测量，同时利用卡尔曼滤波，pid算法等，小车完全可以达到静止不动的状态，希望能够对有同样兴趣的朋友们有些帮助(自己写的)-The independent two wheel balancing car based on Arduino, this is a crystallization of their autonomous learning experiment process, using mpu6
serial-port
- 51单片机实现串口通信，包括发送、接收、收发同时-51 single chip microcomputer to realize serial communication, including sending, receiving, sending and receiving at the same time
spc3dps2
- spc3的输入输出数据交换,F2812的DSP代码，硬件是DSP与SPC3芯片实现DP通讯。-spc3,dsp code
uclinux_net
- 这是一个 在S3C44B0板子,基于UClinux的网络传输程序,send.c是发送AD采集的数据(SEND.C带有AD采集程序).SET.C是设置程序比如采集时间等等.-This is a one in S3C44B0 plank, based on the network transmission UClinux procedures, send.c sending data acquisition AD (AD SEND.C with acquisition procedures). SE
MMC_SD
- stm32f10x的spi低速模式下的SD卡驱动，支持版本号2.0以上的SD卡-STM32F10x the spi low-speed mode SD card driver to support the SD card version 2.0