资源列表
0xfd---00
- keilc51 0xfd 补丁验证程序 SCAN.C(338): warning C280: UpLoadReady : unreferenced label-keilc51 0xfd patch certification procedures SCAN.C (338) : warning C280 type : UpLoadReady : unreferenced label
ASM
- SN75176,用51系列的单片机，波特率为9600，串口方式1，发送数据-SN75176
AT24C02_IIC
- 用C语言实现了IIC协议的访问接口，可以方便的操作AT24系列的EEPROM。-Using C language to implement the IIC protocol access interface, you can easily operate AT24 series EEPROM.
49-200mS-PWM
- 51单片机产生周期为500ms,占空比为50 的方波信号。-51 MCU generation period is 500ms, 50 duty cycle square wave signal.
kaifaban
- 单片机学习资料 有利于学习和观看 。pc与单片机-MCU learning materials conducive to learning and watching. pc and microcontroller
verilog-design-Experience
- verilog设计经验点滴，首先要有所要写的module在硬件上如何实现的概念，而不是去想编译器如何去解释这个module-verilog design Experience
C5000DSPlbq
- C5000系列DSP上实现自适应滤波器的源码，汇编语言编写的，可直接在CCS上运行-C5000 Series DSP achieve adaptive filter source code, written in assembly language. directly run in CCS
gpio-test
- 1、将makefile中的 CROSS =/usr/local/arm/2.95.3/bin/arm-linux- CFLAGS+=-I/usr/local/src/2.4.18-rmk7/include CFLAGS+=-I/usr/local/src/2.4.18-rmk7/include/linux CFLAGS+=-I/usr/local/arm/2.95.3/arm-linux/include 路径改为你宿主机上的。 2、#make，来编译驱动模块。 3、
gpio-test
- gpiotest 嵌入式系统下按键驱动源代码-gpiotest embedded system key driver source code
ddr_model_c3
- DDR仿真模型，采用erilong语言，FPGA开发DDR控制器必备-DDR simulation module verilog
quanpailie.Rar
- 分析：用N进制的方法吧。设一个N个单元的数组，对第一个单元做加一操作，满N进 一。每加一次一就判断一下各位数组单元有无重复，有则再转回去做加一操作，没有则说明得到了一个排列方案。-Analysis: N-band approach with it. A N-unit array, and add a unit to do one operation, over N into one. Add 1 each time you click on an array of modules to dete
code
- si4703的测试程序，里面包含需要定义的常量，以及IIC协议操作程序-si4703 test program, which contains the constant need to be defined, and the IIC protocol procedures