资源列表
C54X_mcbsp
- 在C54X DSP下写的串口收发程序，利用串口收发数据,并在DSP内对数据作简单处理!-under the C54X DSP serial port transceiver written procedures, the use of serial data transceiver, and the DSP within the data processing simple!
STM32_I2C
- 在ATM32的平台上用IO口模拟I2C读24FC256.-Read 24fc256 in STM32 platform,Not use I2C module, but in IO simulation.
PWM
- AVR定时器0的快速PWM实验程序，AVR定时器0的快速PWM实验程序-AVR Timer 0 fast PWM test program，AVR Timer 0 fast PWM test program
pp
- 安卓平板控制的（mini210s）linux系统的小车代码-you
CTC
- 这个程序适用于ATMEGA128的开发板。本程序为CTC模式，功能为PB5和PB6均产生频率为2KHz,占空比为50 的方波（需要把PB5，PB6接到示波器上观察）-This procedure applies to ATMEGA128 Development Board. This program is CTC mode, the function of PB5 and PB6 are generated frequency of 2KHz, 50 duty cycle square wav
ADC
- Source code for sillabs C8051F120 s ADC
1sLEDSHANSUO
- 430单片机定时闪烁LED，很好的测试了msp430g2553的特性-430 single-chip timing blinking LED, a good test the msp430g2553 characteristics
howtocountgates
- 如何计算fpga或cpld门数的资料，希望对大家有所帮助！
51-key-Servo
- 通过单片机开发板上的按键控制舵机的角度变化-using 51 key to control servo motor
I2C-Software-Implementation
- I2C总线协议的软件实现, 可以咋单片机上使用,只要修改时延就可以适应不同的器件-I2C Bus s basic function which is been implemented by software!
SO217B
- 串口锻码液晶驱动程序,连续送入的是3个八位数据,包括,后面的功能知识-Forged code serial LCD driver, a row is placed in three of eight data, including the back of the functional knowledge