资源列表
2-74HC595
- 两个74HC595驱动8位数码管程序，串行输入，3个IO口控制8位数码管，动态扫描，显示稳定-failed to translate
UART_BooQuai
- FPGA上实现UART串口原程序，在ISE6编写的-FPGA serial UART to achieve the original procedure, the preparation of the ISE6
adpcm_compression
- dsp处理器进行adpcm编码压缩的c源代码
I2C.rar
- FPGA实现模拟I2C协议的过程，包括三个模块，i2c_master_bit_ctrl.v完成位传输功能、i2c_master_byte_ctrl.v完成字节传输功能，i2c_master_top.v完成整个程序的控制功能，并提供给外部程序的接口。 ,I2C Analog FPGA implementation of the Protocol process, including the three modules, i2c_master_bit_ctrl.v achieve bit tran
DataShift
- 用单片机和数码管实现的数据移位功能，供初学者学习使用-With the microcontroller and digital control to achieve the data shift function, for beginners learning to use
004liu
- 基于icc avr atmega16 流水灯程序设计-Icc avr atmega16 light water-based programming
linuxminiboot0.8
- 这是Linux环境下的内核引导程序miniboot0.8，由于它的源代码较小，比较适合嵌入式开发者对引导程序的入门。-This is the Linux kernel under the boot miniboot0.8, because of its source code smaller, more suitable for embedded developers to guide the process of entry.
SRAM_256Kx16_TSOP44
- 原理图，256k*16位SRAM，包括芯片连接，退耦电容等-schematic，256k*16bit SRAM，including chipconnection ， decoupling CAP，etc.。
ADC
- 单片机开发学习实验板，关于ad和da转换部分的程序，用c语言写的，简单易懂，适合初学者。-SCM development learning experimental board, about the AD and da conversion part of the procedures, the use of c language to write, easy to understand, is suitable for beginners.
8_1_2016__SdWebBrowse_CC3000_HTTPServer
- SdWebBrowse Ethernet HTTPServer Arduino2
SRC
- 门禁中解码器源程序,解码器在主机和分机中扮演中转视频和语音的作用。-in building video system ,the decode device acts transform video and sound between main device and branch device which place in used room. this code source is mature.