资源列表
C51
- 8051 单片机端口设置程序 基于STC89C51芯片 -8051 port STC89C51 chip-based setup program
kanmengou
- avr单片机初学者适用的单片机例程（看门狗的设计）-avr microcontroller for beginners routine application of microcontroller (watchdog of the design)
MOTOR-Linux-QUDONG
- 写的是关于在LINUX上的步进电机的驱动程序，希望对大家有些帮助-LINUX is written on the stepper motor drivers, we want some help
testPWM
- test PWM on avr atmega8
chaoshengbo
- 超声波测距仪：通过超声波发送和接受探头，发送和接受超声波算出时间，再乘上速度再除以2，即可求出距离-Ultrasonic range finder: send and receive through the ultrasonic probe, sending and receiving ultrasound to calculate the time, and then divided by the speed multiplied by 2, can be obtained from the
chaoshengbo
- 超声波测距程序，发现网上好多不可用，把自己用的发上来-Ultrasonic distance measurement procedures, found that a lot is not available online, use their own hair up to look at
state-machine
- 基于LABVIEW的状态机源代码，NI公司指定中国唯一供应商泛华测控公司提供的内部培训资料。需要用LABVIEW8.6以上版本打开.-LABVIEW-based state machine source code, NI designated China as the sole supplier of Pan-house training provided by the company and control information. Need LABVIEW8.6 later on.
dianzheng
- 运用双色点阵显示两种颜色，并使用串并转换芯片控制数据发送和锁存。-The use of two-color dot matrix display two colors, and the use of a serial-to-parallel conversion chip control data transmission and latch.
MSP430-NMI
- 详细介绍了MSP430的不可屏蔽中断，同时介绍了宝贵的开发经验。-Details of the MSP430' s non-maskable interrupt, also introduced a valuable development experience.
msp430
- 将P6口输入的模拟电压AD转换后，从P4、P5口连接的数码管输出。 使用AD单通道多次转换，采集P6.0输入的模拟电压值（变化范围：0～3.3V），转换为数字量。 建立二维数组和通过顺序查表的方法得出采集回来的电压值。然后通过数码管显示当前电压值，显 示跟随输入的模拟电压的变化。由于只有两位数码管，故显示电压值精确到小数点后一位，如当前 输入电压2.37V，则显示2.4V。可用万用表检测显示是否准确。 -After the P6 port analog volta
Dynamic-LED
- 利用定时器中断，作为延迟函数，数码管动态显示-Use of the timer interrupt, delay function digital dynamic display
TLV5618
- 该程序为DA芯片TLV5618的驱动程序，可以参考修改进行使用。-The program for the DA chip TLV5618 driver, you can refer to modify for use.