资源列表
Sdram_Control_4Port
- sopc sdram 硬核的verilog 源码
hongwaijieshou
- 一般的红外接收头主要由CX2016A，PC1373等集成电路外加阻容元件，红外线接收管及滤波光片等组成，因而体积较大。而新一代一体化红外遥控接收头SFH506-38与RPM-638CBR将红外接收管，前置放大解调等电路集成在同一基片上，内电路框图如图1所示，具有体积小，无外部元件，抗干扰性能好，接收角度宽、价格低等优点。-General infrared receiving mainly CX2016A, PC1373 external RC components such as integr
Demo
- OtoStudio运动控制p2p模式示例-OtoStudio motion control p2p model example
pwm
- 利用ST7单片机的PWM中断，发送PWM信号-Send a PWM signal using an ST7 MCU
DSP
- 有关DSP知识点的总结，写的比较清楚，适合初学者-Summary of the DSP knowledge, write more clearly, suitable for beginners
avr_LED
- avr单片机，采用c语言编写，实现LED小灯循环闪亮-avr microcontroller, c language, the LED lights cycle shiny
choushui
- 抽水机程序，采用HT46R47 可自动检测水压，流水，水满等情况来判断电机是否运行；
vhdl
- 循环码编译码程序，用c语言编程的 该for 循环计算码组的后3 个码元-Cyclic code encoding and decoding procedures, with c language programming cycle of the calculation of the code group for the three yards after the yuan
16-LCD1602
- lcd1602 显示 工程文件 51单片机-Lcd1602 display engineering documents 51 SCM
aculator
- 简单的计算器，实现加减乘除，A8上可以运行，很好的代码，希望大家会喜欢-Simple calculator, implement arithmetic, you can run on the A8, very good code, we hope everyone will like
keyboardP-
- 单个独立按键控制led输出状态 按下加按键，数值增加直到最大值，按减按键，数值减小，直到最小值-Independent control of a single button press the plus button led output state, the value increased until the maximum, according to cut key, value decreases until the minimum
433
- 本代码是基于STC89C52的433无线模块的使用，实现了短距离的无线控制。-This code is based on the wireless module 433 STC89C52 used to achieve a short-range wireless control.