资源列表
MCU_motor_driver
- 单片机控制步进电机的源码，c语言编写，使用于大多数单片机。 用Keil编写-stepper motor control microcontroller source code, c language, the use of the majority of SCM. Prepared with Keil
FIR
- 这是,针对DSP6713,在CCS用,设计的FIR滤波器程序.
PWM
- 通过avr 产生PWM波，实现电机调速，程序通过调试，放心使用-PWM wave generated by avr, the motor speed, the program through debugging, ease of use
MOTOR
- 步进电机旋转角度在数码管显示，使用C程序编程，可通过PROTEUS软件观察结果。-The rotation angle of the stepping motor in the digital display, using the C programming, the results can be observed by PROTEUS software.
CE027_FLASH_Rtsp_091207
- pic单片机PIC30系列C语言编程资料。。。。。加油下啊。
LPC210x_UART0
- ARM_PLC210x在嵌入式操作系统uCOSII下使用串口-ARM_PLC210x in the embedded operating system to use serial uCOSII
5V
- Protel的测电压和电流的电路原理图，连线完整-Protel measuring voltage and current of the circuit schematics, connection integrity
lcd
- 关于液晶显示的一篇比较可以的文章.来自于网路.非我本人所写.-On the liquid crystal display of a comparison article. From the network. Ones I wrote.
digital-storage-oscilloscope
- 本题设计一个数字存储示波器，以Xilinx公司20万门FPGA芯片为核心，辅以必要的外围电路（包括信号调理、采样保持、内部触发、A/D转换、D/A转换和I/O模块），利用VHDL语言编程，实现了任意波形-The problem to design a digital storage oscilloscope, to Xilinx, Inc. 200,000 FPGA chip as the core, supplemented by the necessary peripherals (incl
16位Flash烧写
- 这是一个实现向一块ARM板上移植uclinux2.0的程序,通过PC机的串口1可实现向目标板的flash里面写入uclinux2.0- This is a realization transplants uclinux2.0 together to the ARM board on the procedure, 1 may realize through the PC machine string mouth to inside goal board flash reads in uclin
DS1302
- 最简单的DS1302的电子钟,包含仿真原理图和编译好的16进制文件
ILI9325
- ILI9325驱动，调试环境是NIOS II IDE-ILI9325 driver uesd on NIOS II