资源列表
GPIO-V2-tryfor-stm32103C8BTL
- STM32 Corex M3 定时器加GPIO操作-STM32 Corex M3 plus GPIO timer operation
blmc_source
- 这是一个完整的无刷马达驱动软件源代码工程包，用C语言完成，有注释，参考价值极高。-This is a complete software source code, brushless motor construction package, complete with the C language, annotated, reference value is extremely high.
AN-1013
- μC/OS-II and the Xilinx MicroBlaze
asynram
- 设计32×6位的RAM，其结构图如图2所示。其中，adr为地址引脚，cs、wr、rd分别为片 选、写和读引脚，din_out为输入输出引脚。当cs=0且wr由低到高（上升沿）时，din上的输 入数据写入adr指示的单元中；当cs=0且rd=0时，adr对应单元的数据在dout数据线上读出。 因wr在上升沿时写入数据，因此可以采用TEC-CA平台上的单脉冲按钮作为wr。-Design 326 of RAM, the structure shown in Figure 2. Which,
an10845
- extremely small implementation of the TCP/IP protocol suite intended for embedded systems running low-end 8 or 16-bit microcontrollers
UART
- STM32的USART详细例程，能够使用的，下载完了要给点回复哦！
ADXL345
- STM32 三轴加速度传感器代码 ADXL345-STM32 triaxial accelerometer code ADXL345
motor2
- Verilog编程实现步进电机的单双八拍的四路脉冲信号。采用28BYJ-48步进电机（驱动ULN2003）验证可以实现其正反转。-Single and double eight four-shot pulse signal Verilog Programming stepper motor. Using 28BYJ-48 stepper motor (driver ULN2003) verification can achieve its inversion.
EM78P_MCU.rar
- 义隆仿真器使用资料,全中文资料，希望能对学习义隆单片机的朋友有一点帮助。,Elan simulator and use the information, the English data, Elan hopes to study single-chip microcomputer has a little friend to help.
数字频率计 97
- 比较有帮助，看了就知道了，只发精华贴 谢谢
jtag.tar
- jtag的verilog 代码 包含boundary ce
The_dual-port_RAM-based_FPGA
- 基于FPGA的双口RAM实现及应用,对RAM有一个系统的介绍-The dual-port RAM-based FPGA Implementation and Application of RAM to have a systematic introduction