资源列表
iar4.6.part10
- IAR4.6，NEC单片机编程器，共十个压缩包，含破解文件，可顺利安装，喜欢就拿去。-IAR4.6, NEC microcontroller programmer, a total of ten cabinet, including crack file, can be successfully installed, like to take it.
SPI_UART_I2C-SC16IS752
- NXP 的SPI转UART芯片的资料和驱动，资料全面和详实。-NXP' s SPI to UART chip and data-driven, comprehensive and detailed information.
SIM900A_103RB_精简
- 使用sim900连接网络服务器并且上传数据(Use sim900 to connect to the network server and upload data)
CAN通信应用
- 使用STM32F103ZET6芯片驱动单路can通信,(use stm32 to realize CAN communication)
实验29 游戏手柄实验
- 向大家介绍如何通过 STM32 来驱动 FC 游戏机手柄， 将 FC 游戏机的手柄作为 STM32 开发板的输入设备(To introduce how to drive the FC game player through the STM32 handle, Use the handle of the FC player as the input device for the STM32 development board)
4.硬件STM32-MPU6050
- 用于硬件IIC STM32-MPU6050(Hardware IIC for STM32-MPU6050)
camera_YUV
- 本篇说明文档介绍了基于RX23T单片机的CMOS摄像头图像采集处理程序的编写。主要介绍了如何使用代码生成工具配置本例程所需的UART、简易IIC、外部中断、Port等模块并生成相应的驱动代码，同时对生成的代码文件添加的摄像头驱动与数据存储函数进行了详细说明。后附CMOS摄像头图像采集处理程序源码实例，用户可以结合本例程对RX23T单片机进行摄像头循迹等的拓展应用。(This document describes the RX23T microcontroller based CMOS camer
PIC458-123
- PIC单片机MODBUS总线通信仿真 PIC single chip microcomputer, MODBUS bus, communication simulation(PIC single chip microcomputer, MODBUS bus, communication simulation)
TrioPC_USBActiveX
- ActiveX to talk to a trio controller
ALIENTEK MINISTM32 实验14 待机唤醒实验
- 在stm32的低功耗模式中，待机模式可以实现系统的最低功耗，在这种模式下，只需要2uA左右的电流。(In the low power mode of STM32, standby mode can achieve the lowest power consumption of the system. In this mode, only 2uA current is needed.)
UART
- ARM9系列单片机编程，UART通讯实验-ARM9 MCU, UART communications experiment