资源列表
c
- 单片机高级语言程序设计与应用，以C语言为例-C
K0R_uart_re_C_prj
- NEC官方开发板上的实例,对于没有用过NEC单片机的人来说,是很好的上手例程-NEC official development board example, not used for NEC MCU people, is a good routine to get started
lt-mini-m16-test
- 是针对单片机的开发应用的一个基础视频教程，非常的有利于初级开发人员进行操作。-SCM is a basis for the development and application of video tutorials, very conducive to the development of junior staff to operate.
avr-test
- avr单片机学习调试程序,在GCC环境下编译.非常好的学习资源-avr m16 learning program, compiled in the GCC environment. a very good learning resources
vxworks-note
- 一些关于vxworks bsp make的说明-vxworks bsp make
F350
- C8051F350/2单通道ADC,比较好的样板程序-C8051F350/2 single-channel ADC, a better model procedures
cf_and_8051
- c and 8051 program code document
jiankongzongduan
- 这是本人设计的一个智能家居模型的监控总端的源代码，经过试验，程序都是可以使用的-I designed a model of smart home monitoring end source code, are tested, the program can be used
MakeProc
- 申延超_嵌入式Linux应用开发完全手册笔记_可执行文件的生成过程-Make Proc
ADC0_RTD
- aduc7060的DACC语言编程,一款在传感器和医疗低功耗设备用的比较多的单片机-aduc7060 the DACC language programming, a low power consumption of the sensor and medical equipment used in relatively large number of single-chip
SPI
- // This program accesses a SPI EEPROM using polled mode access. The F06x MCU // is configured in 4-wire Single Master Mode, and the EEPROM is the only // slave device connected to the SPI bus. The read/write operations are // tailored to access
hrlib-0.9.0
- VHDL Program image page show