资源列表
c2xx_self_test
- lf2407自检源代码，完成内部硬件的自检功能
x1226
- 用msp430f149对x1226进行读写-Read and write on the x1226 with msp430f149
EM78P153
- 灯控程序，用摇控器控制家用灯器，采用义隆芯片，EM78P153,已通过生产。-light control, with EM8p153.
exp05_int
- dsp的外部中断程序，与建立的工程，适用于初学者-DSP external interrupt program, with the establishment of project, it is suitable for beginners
uTaskerV14_LPC2478-STK
- This an Ethernet (802.3) Stack, free to download from www.uTasker.com, for LPC2478 ARM7 MCU, with enabled FTP, HTTP, Telnet etc. Flash the MCU with given hex file and access any web page through ur browser.-This is an Ethernet (802.3) Stack, free to
ATmega128--IIC
- ATmega128芯片的模拟IIC实验代码,控制两个24c02eeprom存储芯片读写,并在1602液晶显示屏上显示,带protues仿真图,用avr studio+gcc实现-ATmega128 chip analog IIC experimental code, control two 24c02eeprom memory chips read and write, and displayed on the LCD 1602 with protues simulation diagram,
spectrum_analyser
- 基于TMS320C5416平台的谱分析程序，可以在5416DSK上直接运行-TMS320C5416 platform based on the spectral analysis procedures can be run directly 5416DSK
vvvf
- 基于2407的交流异步电机变频变压控制，c及asm混合编程，值得借鉴下-Based on 2407 exchange control of induction motor variable frequency transformer, c, and mixed-asm programming worth learning from the next
GH
- 51产生三种波形 51产生三种波形-51 generates three types of waveform 51 generates three waveform
interrupt
- 基于S3C2440裸机开发的一个小程序。作用是模拟铁路道口设备功能检测两测是否来车 当来车时相应的灯亮，并等待列车触发另一边的信号 表示车离开。另外 一段时间之后会有灯亮，必须按下一个按键，否则再等待一会另一盏灯就会亮。用来监督人员是否离开。 所有的操作会显示在DNW上。 用到：GPIO 中断 定时器 和串口技术-S3C2440 based development of a small program bare metal. Role is to simulate the two railw
control-temperature
- 利用stm32内部的温度传感器读取温度值。该温度传感器在内部和 ADCx_IN16 输入通道相连接，此通道把传感器输出的电压转换成数字值。温度传感器模拟输入推荐采样时间是 17.1μs。 STM32 的内部温度传感器支持的温度范围为： -40~125度，精度为±1.5℃左右-read the temperature by internal sensor of stm32.
MSP430JTAG
- 这个文档可用于430单片机ITAG口调试和设计应用-This document can be used to debug and 430 single-port design applications ITAG