资源列表
SolarExplorer_PVEmulator_F2802x
- dsp2802x实现的用于光伏发电模拟的模拟器-PV emulator by dsp2802x
一些实用的单片机C程序
- 众多单片机常用的程序，基本上能用到的，都包含在内。(Many commonly used microcontroller program, basically can be used, are included)
14067350
- 单片机51 控制的'直流'电机调速系统，用pwm方法，有加速'，减速，开始停止等功能强大。(The single chip microcomputer 51 controls the 'DC' motor speed control system, with the PWM method, it has the functions of acceleration 'speed', deceleration, starting stop and so on.)
1602LCD_PIC
- 单片机原程序：支持液晶1602 基于 GL7-877A硬件平台(This is source code of supporting LCD 1602 for PIC MCU)
trip_control2
- 使用SH79F166A，编写的掉电延迟函数，供其他开发者参考。(Use SH79F166A to write the power drop delay function for reference by other developers.)
交通灯
- 基于单片机对十字路*通信号灯进行控制，通过数码管和矩阵键盘实现系统功能，包含单片机代码和仿真运行文件。(The traffic lights at crossroads is controlled based on single chip microcomputer.The system function is realized through the digital tube and the matrix keyboard, including the single chip compute
MSP430F5529-UART-RTC
- RTC+UART,可以通过串口发命令控制是否发送时间以及发送的间隔时间(RTC,UARTC,commands can be sent through the serial port to control whether to send the time and send the interval)
温度
- 检测温湿度，采用DHT11传感器，最大温度是50度，最小是0度(The DHT11 sensor is used to detect temperature and humidity. The maximum temperature is 50 degrees, and the minimum is 0 degrees.)
17-IR红外遥控
- 按键控制LED发光二极管，并且可以遥控实现键码值液晶显示(Key control LED led, and remote control to achieve key value LCD display.)
NRF24L01_Tx_UART发送
- NRF24L01_Tx_UART发送avr单片机与NRF24L01结合，发送温度数据(NRF24L01_Tx_UARTSEND)
基于51单片机与zigbee串口联调远程控制系统
- 基于c51单片机的控制系统（实例为加湿器应用）可通过传感器获取环境参数，并通过参数改变自身运行状态。通过zigbee远程传输到PC，用户通过PC即可远程监控并进行操作。(The control system based on C51 microcontroller (example is humidifier) can acquire environmental parameters through sensors and change its running state through par
手柄参考代码
- PS2手柄在51上的程序分析，用于智能小车。(PS2 handle on the 51 program analysis, for smart car.)