资源列表
CC1110CC2510_Example_Softwar
- LSJ－CC1110/CC2510 Example Software Packet Error Rate Application Example
IOcontrol
- C51 ,IO控制，定时器，外部中断，led-mcu timer
usb程序
- 运行于c51单片机上的用keil c创建的C源程序,采用PDIUSBD12接口。-run on the microcontroller with Keil c create C source code using PDIUSBD12 interface.
ourdev_526496
- 个简单的以太网发送速度测试程序，发送的数据是一个固定的UDP报文，循环反复发送，实测PC端网卡占用率 96％，也就是在 96Mbps 左右！-A simple test procedure speed Ethernet sending, sending the data is a fixed UDP packets sent repeatedly cycle, the measured end PC card 96 occupancy rate, which is about the 96Mb
1602JDT
- 在STC51单片机上面实现18B20温度传感器的读取，并在1602液晶上显示当前的温度，并且在1602液晶的另一行上把读取的温度转换成随温度变化的进度条。-STC51 MCU achieve the above 18B20 temperature sensor reads and displays the current temperature in the 1602 and 1602 on the other line of the temperature reading into the p
PROFIBUS_dp设备接口的开发与应用1（终）
- PROFIBUS_dp设备接口的开发与应用1（终）.rar-PROFIBUS_dp Device Interface Development and Application of a (final). Rar
Moving_average_algorithm
- Document detailing the moving average algorithm.
PCB-LIB
- 从业近10年，所积累的PCB封装库，经典啊-从业近10年，所积累的PCB封装库，经典啊 Practitioners in the past 10 years, the library package PCB accumulated, the classic ah
series
- 串口通信，以前做实验时，做了很久。马上要毕业了，这么删除了，可惜-Serial communication, doing experiments to do for a long time. About to graduate, so deleted, but unfortunately
AT24C256
- AT24C256的读写程序，单片机使用ATmega16，同时在LCD上显示-AT24C256 literacy program, MCU ATmega16, simultaneously displayed on the LCD
arm_design
- 基于ARM的数控冲床送料系统的设计，基于s3c2410。-ARM-based CNC punch press feed system design.
Uart_Resolution_Exchange
- MSP430两串口输入 一串口输出 并进行协议解析-Two serial input and a serial output protocol analysis