资源列表
shengyadianlu
- 自己整理的几个升压电路！我觉得比较实用！-Their order of several boost circuit! I think the more practical!
51bujindianji
- 51单片机驱动步进电机电路及程序 内容详细，通俗易懂，很值得-51bujindianji
shenyanghuagong
- 通过单片机的P1口读取矩阵键盘信息，通过单片机处理显示在共阴极数码管上。当输入大于6位实现移位。密码正确指示灯亮-P1 port of the microcontroller reads the matrix keyboard, displayed in a common cathode nixie tube through the single-chip processing. Shift when the input is greater than 6. The password is co
myCom
- 自己写的实现QT串口通信的源码，在6410开发板上运行过，证明可行。-Write your own realization QT serial communication source, in the 6410 development board to run too, proved to be feasible.
PIC_C
- pic单片机实用c程序，ad can rs323 pwm wdt十三个程序文档-pic microcontroller practical c programming, ad can rs323 pwm wdt thirteen program documentation
C51-16key
- C51单片机开发板与汇编语言的矩阵键盘的简单调试程序-C51 microcontroller development board and a simple debugger for matrix assembly language keyboard
Speech-signal-transmission
- 利用DSP的SPI同步串行接口驱动语音芯片，实现DSP和音频接口芯片之间的数据采集和传输。-The use of DSP SPI synchronous serial interface driver voice chip, chip DSP and audio interface between the data acquisition and transmission.
触摸屏驱动代码
- 触摸屏驱动开发源码 S3C2410 ADS7843
S3C2410
- 基于S3C2410的触摸屏源程序，-Design of touch screen driver in embedded Linux
liushuideng
- 单片机protues软件单片机仿真程序流水灯-The the microcontroller protues software microcontroller simulation program of light water
fae6f2b1-b162-403d-9672-14d2cd
- 用热敏电阻测量温度及其温度显示的C语言程序,With thermistor temperature measurement and temperature display C Language Program
can_tx
- TIc6000 32位定点DSP DM6437 CAN总线发送程序-TIc6000 32-bit fixed point DSP DM6437 CAN bus to send program