资源列表
256TaskuCOSII
- 256个任务的uCOSII，经测试非常稳定。-256 tasks uCOSII, tested extremely stable.
ADC
- LPC2103，ADC源码，很好用的，IAR环境下编译
led_flash
- C5402板卡小灯测试程序，利用了定时器，可能具体板卡不同，但可提供参考-C5402 board a small lamp test procedure, and use the timer, may be different from the specific board, but can provide a reference
ds1302_uart
- 本程序采用kiel开发，使用DS1302作为时钟源，八位数码管进行动态扫描显示时间，并可以由上位机发送“R/r”（read）命令由单片机发送时间和日期信息到上位机-The program uses kiel development, use DS1302 as the clock source, eight digital tube dynamic scan display time, and can be sent from the host computer " R/r"
ADC
- STM32F103 ADC EXAMPLE
VerilogEP2C8Q208PLL_12MHz
- Verilog HDL语言编写EP2C8Q208芯片PLL分频的简单程序 PLL_12MHz-Verilog HDL language EP2C8Q208 chip PLL frequency of the simple program PLL_12MHz
ADC0809-and-C51-program
- AD0809数模转换芯片与单片机的连接仿真电路，并且C51编程实现了其与单片机的联合调试仿真，可以作为一个功能模块使用-Simulation circuit of the AD0809 digital to analog conversion chip microcontroller connected, and the C51 programming to achieve joint debugging emulator with microcontroller can be used as
ALIENTEK-MINISTM32
- stm32 lcd帧统计例程在timer.c中增加了一个全局变量，通过定时器定时1s钟，然后统计这个时间内LCD的刷屏次数，再通过串口打印出来刷屏的速率。-stm32 lcd frame statistical routines increase in timer.c in a global variable timer timer 1s bell, and then statistics this time, the LCD refresh the number, then refresh t
smg_interface
- FIFO高速数据采集处理，串口发送接收封装，独立于上一模块，-FIFO high-speed data acquisition and processing, sending and receiving serial package, independent of the previous module,
RX_operation
- Si4432 无线单接收例子代码。(基于C8051F930)-The Si4432 the wireless single receiver example code.
usb_i2c
- 基于Cypress的68013实现的USB转I2C的源代码。USB端通信是利用预留指令0xA3实现的，基于最简单的控制流程。适合大家初步接触USB编程的人。下端用C51模拟I2C总线。-68013 Cypress-based implementation of the USB-I2C source code. USB client communication is the use of reserved instruction 0xA3 to achieve, based on the most
pwm
- 89c51生成PWM方波，使用定时器，占空比频率可调-89c51 generate a PWM square wave, using a timer, frequency adjustable duty cycle