资源列表
shanshuoliushui
- verilog实现闪烁灯和流水灯dechengxu-verilog liushuideng shanshuodeng chengxu
LCD_1602
- 用proteus画原理图，在keil中进行编程，两个连在一起进行仿真。-Schematic drawing with proteus, programming in keil in two simulated together.
ov7670
- 摄像头驱动，是最近用AVR调试的，但是没有验证能不能用，请大神帮助！-Camera driver, was recently debugging with AVR, but can not be used without verification, please god help!
MC6812
- Motorola 6812芯片开发的接口程序。-Motorola 6812 chip development of the interface program.
AVRSmgOneKey.DSN
- AVR单片机ATmega16L基于状态机的独立按键Proteus仿真-
c51流水灯
- 流水灯.c文件以及.uvproj文件，可以直接使用
led_flash
- 用软件CCS3.1编写的一个DSP程序，功能是让输出灯闪烁。-Software written in a DSP program CCS3.1, function is to allow the output light flashes.
AD7799
- ADI公司的模数转换器AD7799官方驱动程序，测试可用。-ADI s AD7799 ADC official driver test is available.
dsp
- Pwm输出信号的设计 试设计四路（PWM1,PWM2,PWM3,PWM4）输出，载波频率为8ms，波形关系如图所示（一个周期）： -Design test design four (PWM1, PWM2, PWM3, PWM4) output Pwm output signal carrier frequency of 8ms, waveform relationship shown in Figure (a period):
READRC5
- RC5 project Schematic and Source code
传感器51测试程序
- 这个是光敏二极管的的C51程序，我也不知道怎么样，还要调(This is the C51 program of photosensitive diode. I don't know how to adjust it.)
Proteus程序1
- 使用Proteus程序，P1口做输入口，接八个开关，以74LS273做输出口编写程序读取开关状态，在发光二极管上显示出来。(Using the Proteus program, the P1 port is the input port, and then eight switches are connected. The program reads the switch state with the 74LS273 as the output port and displays it on t