资源列表
ledcubeC2
- led cube with pic microcontrollers, full code.
nrf24l01-read-only.tar
- 非常经典的24L01收发程序，使用SPI，底层驱动是AVR的，稍微改变一下可以用到各种控制器上。-Very classic 24L01 transceiver procedures, the use of SPI, the underlying driver is the AVR, slight change can be used on a variety of controllers.
loader
- C8051 silabs usb software -C8051 silabs usb software
interrupt-1-6s-check
- 单片机的定时循环扫描程序，定时器6s中断，同一信号扫到三次，立即停止中断，信号改变再次打开中断。-The the microcontroller timing cycle scanner timer 6s interrupted the same the signal sweep to three, to immediately stop interrupt, the signal changes once again open to interrupt.
MS5534
- 实现ms5534与c51的链接驱动，keil编译通过，需要的自己下了-The link with the c51 to achieve ms5534 driver, keil compiler passed, the needs of their own down the
x
- 基于MPS430单片机对电池充放电的安全检测，并使用LCD12864液晶显示其曲线图像。-MPS430 microcontroller based on the safety of the battery charge-discharge testing, and use LCD12864 liquid crystal display images of their curves.
AT89C51-12864LCD-experiments
- 基于AT89C51的12864显示实验，开发环境是keil-Based on AT89C51 12864 experiments, the development environment keil
timer3
- 在KEIL4环境中，用定时器3准确定时一段时间，这个程序是定时10ms，可以通过更改分母，来改变定时时间-In KEIL4 environment, using timer 3 accurately timed period of time, this program is timed 10ms, the denominator can be changed to alter the regular time
co2pwmmsp430
- msp430f149 中利用上下沿触发有效，求出CO2传感器发来脉冲宽度，进而求出CO2的浓度(实际已经应用)-Using up and down along the trigger effective msp430f149, and CO2 sensor pulse width, and the concentration of CO2
fpga_led
- 这个源代码是由专业人士编的，其作用是点亮数码管，检验开发板的好坏！-This source code is made by professionals, and its role is to light up digital tube, test development board is good or bad!
NO.18-ADC0832-conversion-and-display
- 《单片机C语言程序设计实训100例——基于8051+Proteus仿真》案例压缩包 第 02 篇 第 02 篇 硬件应用 18 ADC0832模数转换与显示-" Microcontroller C Programming Language Training 100 cases- based on 8051+ Proteus simulation," Case No. 02 cabinet hardware application No. 02 18 ADC0832 analog
yaokonshumaguan
- 用红外线遥控数码管，是个C语言的源码，可以直接使用哦-Use infrared remote control digital tube