资源列表
4Timer
- 4位数码管计时器，用来实现计时功能。本代码使用C51芯片。-Four digital control timer used to implement the timing function. This code uses the C51 chip.
IRQ
- ARM嵌入式系统关于IRQ中断处理基于c语言的实验代码-ARM Embedded System on the IRQ interrupt handling of the experiment based on the c language code
armJtag-DevelopmentGDB
- 基于GDB的JTAG开发源代码。。。 里面代码还是比较详细的。希望有帮助。支持源码开放。-GDB-based JTAG development of the source code. . . Inside the code is quite detailed. Hope that helps. To support open-source.
8051Pproteus-27
- 《单片机C语言程序设计实训100例——基于8051+Proteus仿真》案例压缩包 第 01 篇 基础部分27 TIMER0控制单只LED闪烁-" Microcontroller C Programming Language Training 100 cases- based on 8051+ Proteus simulation" case archive basis of Article 01 part 27 TIMER0 single LED flash contr
PNX1700_btscriptgen
- NXP trimedira PNX1700的btscr iptgen，方便生产各种boot程序。
S3C2410_stepmotor
- 利用ADS1.2开发的S3C2410平台下步进电机程序-use ADS1.2 S3C2410 development platform stepper motor procedures
PTR8000
- 用于单片机上8000无线的应用,半双工工作模式，希望对大家有用-Used for the single 8000 wireless applications, half-duplex work mode, hope of the useful
hid_keyboard
- 蓝牙HID键盘源代码，使用CSR芯片，版本：BlueLab 4.1.2-Release；包含简要源码说明文档-Bluetooth HID keyboard source code, using CSR chip, version: BlueLab 4.1.2-Release contains brief source documentation
lingyangMCU_Tcp_IP
- 该代码是在凌阳单片机上实现Tcp/IP协议的代码。通过它可以让单片机接入互联网。-the code is in Sunplus SCM achieve TCP / IP protocol code. Through its SCM can allow access to the Internet.
1602
- 1602液晶显示程序，可以简单的测试各个引脚的焊接好坏-1602 LCD, you can simply test each pin of the welding is good or bad
HW
- stc152k61s2红外解码，串口接收解码数据-stc152k61s2 IR decoding, the receiver decodes the serial data
RC522
- 基于51单片机的STC89C52，RFID射频卡对接单片机实现餐卡充值。-51 microcontroller-based STC89C52, RFID radio frequency card docking MCU meal card recharge.