资源列表
library
- STC 单片机 基础库， 包含大多数寄存器操作。(STC mcu basic libary)
超声波测距（LCD1602显示）
- 接线说明; Trig ------- P2^1; Echo ------- P2^0; VCC -------- +5v GND -------- GND 请在上电之前，检查好接线是否正确。(Wiring instructions; Trig - P2^1; Echo - P2^0; VCC - +5v GND - GND Please check that the wiring is correct before power on.)
new_simulation
- 通过时钟使普通的IO口模拟UART串口通讯(Use Timer_A CCR1 hardware output modes and CCR0 SCCI data latch // to implement UART function @ 2400 baud. Software does not directly read and // write to RX and TX pins, instead proper use of output modes and SCCI data // la
LCD12864
- LCD 显示 驱动程序 本人亲自调试 可以用于 avr atmage16dpj(LCD display driver, I personally debugging, can be used for AVR atmage16dp)
MSP430_PWM_IN1
- 通过按键可以调节TB输出PWM波的频率，频率从1Hz到50Hz分辨率为1(You can adjust the frequency of the TB output PWM wave by the button)
I^2C总线
- 89C51单片机 i2c初始化及数据发送(89C51 single-chip i2c initialization and data transmission)
Funny Technology-20170913T135627Z-001
- iksjvmioskhvnidpksvlcoj admsipvk;jadip jadm pd;j m
实验3：LED流水灯
- 用C51单片机进行流水灯控制，每秒闪烁一次(C51 microcontroller with water light control, flashing every second)
eeprom
- pic communication with the 24AA01 EEPROM
通讯3bit显示程序
- 89C2051驱动3位数码管显示程序，接收主机能过串口发过来的数据并显示。用于面板显示表头。(89C2051 drive 3 bit digital display program, the host can send data through the serial port and display. For panel display header.)
数字电位器控制编程
- 单片机控制数字电位器x9313的编程。本编程结合运算放大器设置成一个可调电源，通过单片机控制电位器的阻值修改电位器两端电压从而达到数控电源的效果。电压值可通过单片机外界LCD显示。(Programming of digital potentiometer X9313 controlled by mcu. This program is combined with operational amplifier set into an adjustable power supply, through
LED灯
- 实习多种功能流水灯，速度，LED灯盏数控制，跑马灯。(Practice a variety of functional water lights, LED speed, the number of lamps control, marquee.)