资源列表
wwfgcghjm
- 这是个直流电机程序，拷贝后直接运行即可，适用于嵌入式开发-this is a DC motor procedures, copy operation can be directly applied to the embedded development
ARM1138Interrupt
- EASYARM1138单片机的InterruptC程序-EASYARM1138 SCM InterruptC procedures
SendStr_C
- ARM7的串口收发程序，使用的是ADS，简单易用，可以参考-ARM7 serial transceivers, the use of the ADS, easy to use, can refer to
timer2
- stm8的timer2例程，利用溢出中断，实现1s，LED闪烁一次-stm8 the timer2 routine, the use of overflow interrupt, to achieve 1s, LED blink once
NOKIA3300LCD
- 诺基亚3300彩色液晶256色显示单片机源代码（包含英文字库，16X16汉字程序等，绝对可用）-Nokia 3300 color LCD 256 color display microcontroller source code (including the English character, 16X16 Chinese procedures, the absolute available)
8051LCDDriver
- 基于单片机的led数码管字符显示，可简单的显示以便好的字句-Based on single-chip digital tube led display characters may be simple in order to show the good words
shishizhong
- 实时钟，可用按键调节时间显示，时，分秒都有显示，很方便-Real-time clock, available buttons to adjust the time display, every minute has a very convenient
DS18B20TEM
- 以DS18B20单总线结构实现对温度的测量及控制，并用LCD显示之-DS18B20 single bus architecture to realize the temperature measurement and control, and with the LCD display of
c8051f310SD
- 采用c8051f310读取sd卡的数据,初始化,复位,等都是采用了模块化-Sd card reader with c8051f310 data, initialization, reset, etc. are all modular
基于51单片机数字电压表的设计
- 以单片机为核心，设计一个数字电压表。完成原理图设计，软件编制及设计报告。具体要求如下： 1）对1路模拟信号连续采集16次，取平均值。 2）分别设定每一路的上限值，如采集的平均值超过上限值，则对应通道的指示灯闪烁10次后一直亮，并发出声音以示警告。
ICCAVR_mega8dgkfdhk
- AVR单片机 atmega8单片机 两位数码管显示 proteus仿真和ICC程序 -Atmega8 microcontroller AVR microcontroller two digital display proteus simulation and the ICC program
zigbee-cc2530-led---and-hex
- cc2530 led灯闪烁，完全测试可用，建好工程设置好，编译出hex-cc2530 led lights flashing, complete test is available, and set up the project set up, compile hex