资源列表
RR
- 读取水的温度，对水温进行控制，并控制好水温变化的快慢，-Read the water temperature, water temperature control, and control the speed of a good water temperature,
adc0804
- adc0804同样适用于 C语言 外加PROTEUS仿真图，这些是在学校做的，以后会陆续上传全部，与大家分享-adc0804 same applies to the C language plus the PROTEUS simulation diagram, these are done in the school, will continue to upload after all, to share with you
exacttimingbuzzer
- 这是一个有关精确定时蜂鸣器的小程序，此程序对于初学51单片机的同学来说是非常有益处的。-this is a small program about exact timing buzzer.The program is very useful to the beginner of 51 single chip computer.
PS2
- 通过PS/2接口连接键盘来实现对键盘输入键的识别-PS/2 interface for keyboard input key identify
51-1602
- 基于Keil的51工程-1602移位显示-51 works based on Keil-1602 shift display
SD
- SD卡实验程序，在51单片机上显示，希望对初学者有用-SD card experimental procedures in 51 SCM show that the hope useful for beginners
Demobuttonprogram
- YB-51-A单片机通用实验板按键和液晶屏显示演示程序通过本程序可以进一步熟悉单片机的中断-YB-51-A single-chip Universal board and LCD screen display button demo program through this program can become more familiar with the SCM interrupt
Stepper-motor-driver
- 基于单片机的步进电机驱动程序，用C语言编写-Microcontroller-based stepper motor driver using C language
24VQUDONG
- 一个基于STC11F02E单片机的H桥的电机正反转电路，-A microcontroller based STC11F02E H-bridge motor reversing circuit,
counter
- 运用C语言编写一个简易的计算器，进行加减乘除等运算，方便-The use of the C language calculator, addition and subtraction, multiplication and division operations
Timer(C)
- ADSP-BF561 EZ-KIT Lite s 定时器程序。该程序在visual DSP++环境下用c语言开发。-ADSP-BF561 EZ-KIT Lite s timer program. The program in the visual DSP++ environment using c language development.
MzT24_Driver_SPCE061
- 256色程序编写方法. tft lcd的。2.4寸lcd， mcu控制。-256 color programming methods. Tft lcd s. 2.4-inch lcd, mcu control.