资源列表
juchib0
- 用计数器来实现递增锯齿波以及递减锯齿波的程序设计-Using counters to achieve incremental and descending sawtooth sawtooth Programming
DS1802
- c51控制ds1820在1602上显示温度-C51 control ds1820 in 1602 to show the temperature
PCF8591
- PCF8591 三路A/D，一路D/A程序，调试通过。-PCF8591 three-way A/D, all the way to D/A, debugging through.
CC2530LCDTest
- 利用cc2530来进行点阵LCD的显示并能够成功显示数字和部分图像-Use of cc2530 to dot matrix LCD display
pwm
- 51的pwm程序可以实现pwm波形输出再外加一些电路可以组成波形发生器-Program 51 pwm pwm waveform output can be achieved and then plus some circuits can be composed of a waveform generator
msp430pwm
- msp430f basic pwm outsoucing
uart
- uart全功能实现.实现如下函数: U_Open, U_Close, U_GetBytes, U_PutBytes, U_GetBytesAvail, U_GetTxRoomLeft, U_PutISRBytes, U_GetTxISRRoomLeft, U_Purge, U_SetOwner, U_SetFlowCtrl, U_ConfigEscape, U_SetDCBConfig, U_CtrlDCD,
Hi_H.264_Deinterlace_SDK_LIB_V1.1.0.2
- 华为海思视频处理SOC方案Hi3510客户端软件H.264_Deinterlace SDK-Huawei Hass video processing SOC program Hi3510 client software H.264_Deinterlace SDK
can_self
- 单片机的CAN程序，采用的CAN芯片为STC1000.可以自测等-CAN MCU program, using the CAN chip STC1000. To self-test, etc.
spra803
- 有关CF卡的读写程序，希望能对大家有点帮助-the CF card reading and writing procedures in the hope that we can help a bit
sdfv
- New program tested for checking touch screen controller
dianpingceshi
- 设计一个高低电平信号的测试电路，功能如下： 1． 测量范围：低电平UL<0.5V ，高电平>5V 。 2． 用高音表示被测信号为高电平。 3． 用低音表示被测信号为低电平。 4． 当被测信号在0.5V～5V之间时，不发出音响。 -Design a test circuit high and low signal, the following functions: 1. Measuring range: low UL <0.5V, high level&g