资源列表
I2C
- 基于单片机MSP430的iic存取程序。
18B20-digital-pipe-display-
- 温度传感器18B20数码管显示(加详释)(关于郭天祥老师TX-1学习板程序) -18B20 digital display temperature sensor (plus explaining) (TX-1 for Guo Tianxiang learning board Teacher Program)
DAC0
- 本例直接采用应用笔记案例.实现DAC模拟信号输出，由T4定时控制DAC0输出DTMF信号-Application note in this case by case directly. Realizing DAC analog signal output from the T4 output DTMF signal timing control DAC0
TLC2543
- TLC2543电压采集程序C51,已经通过程序测试-TLC2543 voltage acquisition program C51, has been tested through the program
ftpdLib
- vxworks 下FTP源代码,支持认证登陆和WINDOWS下的FTP软件的查看和编辑
LED164new
- 该程序主要实现通过74ls164实现串行驱动LED并显示,这种显示方法的LED量度较大-the main procedures adopted 74ls164 Serial LED driver and showed that This method showed a larger measure of LED
Jlink_FirmWare_v7_FULL.rar
- JLink V7 固件，自制Jlink所用，请勿用于商业目的。该Jlink固件支持升级。,JLink V7 firmware, made Jlink used, not used for commercial purposes. Supporting the Jlink firmware upgrade.
FW144PBootloaderHEX
- PIC18F458 firmware for tool using as diagnostic for car. Just re-flash the PIC and that s all. everything in.
timer
- 此程序额为msp430的定时器程序源码，大家使用时只需根据需要适当修改就可以了。-This program amounted msp430 timer program source code, we use only the appropriate modifications can be necessary.
maibotiaodong
- 医院脉搏跳动监测仪，用于监测人的脉搏，看心脏功能是否正常，很好的图形见面，简洁实用。-Hospital pulse monitor for monitoring the person' s pulse to see if heart function is normal, good graphics to meet, simple and practical.
Single-phase-motor-SVPWM-control
- 使用C语言编写的单相电机SVPWM控制程序 p30f40-Single-phase motor SVPWM control program written in C p30f4011
51printf
- printf()函数方便调试，但占用了更多的资源开销-Printf function to facilitate debugging, but to occupy the resource cost more