资源列表
fm24c16驱动
- 24c16源代码，经过验证，已经在许多地方使用过。-24c16 source code, proven, in many places use.
0361
- NEC 78f0361 LCD 的驱动程序-NEC 78f0361 LCD Driver
CH451_INT1
- 在数码管上显示按键值（基于单片机中，串并口转换芯片ＣＨ４５１的数码管显示功能）-the digital keys displayed on the control value (based on the single-chip microcomputer, Series Parallel conversion chip LED digital display tube)
stepping_motor
- 步进电机起/停,正/反循环控制程序 1.按下一次开关SW2,步进电机顺时针旋转,按下一次开关SW1则停止 再按下一次开关SW2,步进电机反时针旋转,再按下一次开关SW1则停止 重复上述操作,则会出现同样现象 2.按下任意键,退出
18B20LED
- using 18b20 to detect the temp,and show it o-using 18b20 to detect the temp, and show it o
DS1802
- 此程序为经典的DS18B02温度头控制程序基于c51平台的一种全新写法.占用内存小,所写的代码全部包含注释,适合新手学习-This procedure for the classic first DS18B02 temperature control procedures c51 platform based on a new wording. Small memory, contains all the code written by the Notes is suitable for nov
51_SED1335
- 自己打通LCD用的sed1335程序 简单，易懂-LCD open up their own procedures used sed1335 simple, easy to understand
uMsg
- 关于c51串口通信的程序示例，有详细的注释-A sample for new programers who study C51
nrf905-433jieshou
- 该例程为NRF905频段的接收程序，spi通信原理较为简单易懂-The routine procedure for the NRF905 band receiver, spi communication theory is more straightforward
ssse
- LED点阵显示程序 使用C语言编程 附加网站上有图片-LED dot matrix display program using the C programming language on the website with pictures attached
measure
- 采用单片机读取ds18b20温度传感器的温度，并可以将其显示在数码管和串口上！-Microcontroller reads the temperature sensor using the temperature ds18b20, and can be displayed on the digital control and serial port!
GDrayRes
- 基于STM32F107VC的通过ADC采样计算光敏电阻阻值应用于光度控制。-Based STM32F107VC by ADC sample calculation applied to the photosensitive resistor brightness control.