资源列表
c8051f330_pwm_
- c8051f330输出PWM控制电机简单寻轨
16key
- MSP430驱动四乘四按键的源程序，大家可以学习一下编写程序的格式。
CCPPAR
- 基于ccp协议在下位机中的驱动代码头文件-Ccp protocol based on the drive the next bit machine code header files
红外解码程序
- 红外解码程序 51单片机 红外解码程序 51单片机
santaidianjideqidongkongzhi
- 用plc编程实现三台电机的启动控制 在工业控制中常常会碰到-Plc programming with the launch of the three motor control in industrial control usually encounter
verilog
- 一个可以综合的Verilog 7段秒表实例。上海交大微电子学院课程作业。-An example Verilog project. 7-segment
pal16r8
- manual vhdl descr iption
motor-speed-control-c-program
- motor speed control c program
sanjiao1
- 雕刻机三角形试机程序，请不要装刀具，以免发生事故-The triangular test machine engraving machine program, please do not install the tool, in order to avoid accidents
LAB-PROGS1
- VHDL Programmes -1 for dumping on FPGA
tlc1543ad
- tlc1543AD转换，检测气体，超过上限报警-tlc1543AD conversion, detection of gas, exceeds the high alarm
sE2PROM
- 本程序是基于DSP2812的I2C读写程序，已经通过实际验证，完全满足应用要求，是很不错的源程序-This procedure is based on the DSP2812 I2C read and write procedures, has passed the actual verification, fully meet the application requirements, is a very good source