资源列表
cmp
- c8051f040中比较器0调试程序，带中断处理和比较器状态crossbar输出源程序-C8051f040 comparator debug program, include interrupt process and comparator status. crossbar outputting the source program
led_5
- //串行驱动led显示， //一个74hc595位移寄存器驱动三极管驱动led位， //两个74hc595驱动led段，方式位5位x8段x2=10个数码管 //5分频，每次扫描时间位1.25ms-/ / Serial Driver led, / / a 74 hc595 displacement Driver Register triode-led drive, / / 2 74 hc595 led drive, 5-way x8 of x2 = 10 digital control
buttons
- ARM之BUTTON的测试程序，空板操作的！
ds18b20
- 18b20温度传感器，单总线结构，编程时时序极为重要，测试可用。-18b20 temperature sensor, single-bus structure, timing is extremely important to programming and testing is available.
Timer-ADC-P-DMA-transfers
- 定时器触发扫描模式ADC+DMA传输（寄存器版本）-failed to translate
FLASHDRV
- AT29C040，W29C040及其兼容小扇区，5V，FLASH MEMORY 读写程序。这类芯片扇区为256字节。MX29C040等512字节需修改扇区字节数据。本程序在成功应用在三菱M30802，M30620等系列CPU上。供参考。-AT29C040, W29C040 small sector and its compatibility, 5V, FLASH MEMORY read and write procedures. Such chips for 256-byte sector. M
The-speed-table
- 用单片机设计的测速表源程序。测量转速，使用霍尔传感器，被测轴安装有12只磁钢，即转轴每转一周，产生12个脉冲，要求将转速值（转/分）显示在数码管上。-The speed table with a single-chip design source. Measurement speed, the use of Hall sensors, the measured shaft with 12 magnets, one revolution of the shaft each produce 12 p
pyball
- Hex type memory file. Used to update memory in a simple MIPS processor
MAX232_WIFI
- 这是基于NRF24L01和STC89C51的无线通信程序，该程序详细介绍了编程中遇到的问题和解决途径的途径，该设计运行良好。-This is the way to wireless communication based on NRF24L01 and STC89C51 program, the program details the problems encountered in the programming and the solution designed to run well.
song
- 这是个很有意思的设计，也是dds实验中的一个设计--电子琴-This is a very interesting design, and is also a dds design of the experiment- keyboard
sram_test
- SRAM read/write example
IR
- 对应遥控器（9016）的解码程序，用verilog硬件描述语言编写。-Averilog file about the decoding of the remote-control unit of 9016.