资源列表
LED点阵模块4扫描驱动电路
- LED点阵模块4扫描驱动电路-LED dot matrix scanning module four drive circuit
DS18B20led
- DS18B20液晶显示 602液晶关键在于分清1、初始化参数2、写指令3、写数据4、合适的时序及延时 为方便不进行忙检测，直接延时多增加一点-DS18B20 liquid crystal display 602 LCD key is to distinguish between an initialization parameter, write instruction 3, write data, the appropriate timing and delay For the co
23456
- DSP处理，经典的FFT变换C源代码，我参考过很多其他的FFT程序，但我认为这个是最好的
LCD16024line
- LCD1602 4线连接方式可以达到只使用7个I/O口即可满足要求-LCD1602 4 wire connection can be achieved using only seven I/O port can meet the requirements
eeprom_use
- stc 单片机的eeprom的使用，简单的擦写等。-stc eeprom microcontrollers use flash and so simple.
key_master_0621
- 关于4*4矩阵键盘扫描电路verilog代码设计，支持Avalon总线-On the 4* 4 matrix keyboard scanning circuit verilog code design, support Avalon bus
pwm
- 51单片机按键控制产生pwm并控制转速，数码管显示转速。-51 single button control and generate pwm speed control, digital display speed.
X1205_IIC_Interface_Program
- 本程序是EEPROM X1205芯片IIC通讯接口配置程序，并早已成功通过实际项目验证测试，请大家放心应用。-This program is EEPROM X1205 chip IIC communication interface configuration program, and has already successfully passed the validation test of the actual project, please rest assured that applic
msp430g2xx3_uscib0_i2c_01
- I2C接口TMP100温度传感器在9位模式。 计时器一CCR0中断用于醒来,读这两个字节的 TMP100的温度寄存器每62毫秒。如果温度大于28 c,p1 0设置,否则复位。在LPM0 CPU操作。 速度~ 100 khz I2C。-I2C interface to TMP100 temperature sensor in 9-bit mode. Timer_A CCR0 interrupt is used to wake up and read the two bytes of
Environment
- Global environment configurations for showing soft keyboard and candidate view Source Code for Linux.
code
- uld2003驱动芯片，五线双八拍步进电机。-ULD 2003 driver chip, dual eight-beat five-wire stepper motor
spi
- It is a Verilog code for SPI master. It includes source code and a testbench to test the functionality.-It is a Verilog code for SPI master. It includes source code and a testbench to test the functionality.