资源列表
top
- RS232串行通信，采用VHDL编程，由波特率发生器，接收器和发送器构成-RS232 serial communication using VHDL programming, by the baud rate generator, receiver and transmitter constitute
ALUnew
- Half Adder which is implemented in gate level
lcd1602
- lcd1602液晶显示程序 FPGA控制-1602 LCD control program FPGA
1602jtxs
- 1602液晶显示器的头文件，主要功能是进行lcd的初始化，及写指令、写数据、检测忙碌状态、读数据、输出字符和字符串子函数程序。主函数中写出显示的光标地址和要显示的字符串就可进行仿真。用于初学lcd的朋友，可进行简单的显示字符串。-1602 LCD header file, the main function is to carry out lcd initialization, and write commands, write data, detect busy state, read dat
I2C
- I2C驱动程序，已经调试成功。参照PDF时序图看看就懂。-this is a I2C Driver
delay
- 一个基于FPGA的VHDL编写的延时程序。-A delay procedures based on FPGA VHDL written.
18B20Pyejingxianshi
- 基于单片机的和18B20温度芯片的程序，液晶显示，经过调试成功的-Based on SCM and 18B20 temperature chip procedures, LCD, after the successful commissioning of the
Sine-wave-generator
- 正弦波发生器，发出标准正弦波，很有用，希望有启示作用-Sine wave generator
seq_detector
- 3比特的任意二值序列检测器(例如101、110、001等)。从任意序列中检测出三比特的序列。包含VHDL源码以及testbench测试源码程序。-The 3-bit binary sequence of any detector (e.g., 101,110,001, etc.). A three-bit sequence is detected from an arbitrary sequence. Includes VHDL source code and testbench test so
usart
- STM32F407的USART的应用例程-The application of the USART STM32F407 routines
main
- BCM的遥控接收软件 1、由主CPU的RF_IN发高电平进入学习状态，低电平退出学习状态 2、学习完成1pcs遥控器，由RF_OUT返回1脉冲给主CPU 3、工作时收到有效遥控信号时，由RF_OUT返回主CPU按键盘值数据，为4bit-BCM remote control software 1, the main RF_IN of the CPU to enter the learning state of high level, low level of learning s
DSP281x_Device.h
- DSP2812 Header file a port of the code