资源列表
ds1820
- 温度传感器ds1820 的汇编程序 单片机:89C51晶振：12M
LCD12864
- LCD12864的C51并行C程序 本人亲测，绝对没有问题，如果不对，请注意你的端口定义
autobaud
- C8051检测用户设定的波特率，然后初始化自己的波特率。-This code attempts to automatically detect the user s baud rate and initialize the 8051 s built-in uart. More specifically, these steps are taken: 1.If the code was assembled with the correct baud rate, skip to step 5.
a
- 温度报警器，较完整的程序，含温度检测和设置，报警系统-Temperature alarm, a more complete procedure, including temperature measurement and set the alarm system. . . .
sinduopinlv3
- 本程序为正弦波发送程序，有数学函数SIN发生，通过条件编译可以更改相应的频率，-This program is sine wave sent procedures, mathematical functions SIN occur, conditional compilation can be changed by the corresponding frequency,
MSP430FR57xx_uscib0_i2c_05
- MSP430FR57xx Demo - USCI_B0 I2C Slave TX single bytes to MSP430 Master Descr iption: This demo connects two MSP430 s via the I2C bus. The master reads from the slave. This is the SLAVE code. The TX data begins at 0 and is incremented each ti
EEPROM
- 软件模拟I2C时序读写铁电内数据参考代码，可直接调用其中语句。-I2C Timing simulation software to read and write data within the ferroelectric reference code, which statement can be called directly.
multi-function-remote-control-car
- 使小车前进、后退、左转弯、右转弯、左滚动、右滚动的基本指令-Hardware and software design process for multi-function remote control car
315MHz
- 一下是接收程序: /*** *** *** *** *** *** *** *** *** *** *** * copyright :xiaojunhai filename :.h RF :315mhz RF rate :200byte/S writeby :xiaojunhai date：2209-3-8 波形图： __-----_____-_--_--_-_--_-_--_-_-----_____ l synl sy
main
- 用单片机控制UART，实现kalman滤波的的简单算法，仅供参考-Use MCU to achieve Kalman filtering
spi
- 通过软件模拟io方式实现spi全双工通信-soft spi
interrupt
- map430单片机串口收发中断的机制经典例程-the uart example of interrupt for msp430