资源列表
l298
- l298调 速 程 序 常规的接法是这样的，EnableA接PWM信号，Input1输入正反控制信号， Input2是Input1经过反相以后的信号。L298的电平是与TTL电路相兼容的，一般是超过2.5V就为高电平。假如Input1为高电平时电机正转，那么低电平时就是反转，PWM信号控制电机的转速。 _________________
pca.rar
- C8051F系列单片机利用PCA捕捉模块进行脉宽测量,C8051F series microcontrollers use of PCA capture module pulse width measurement
LED3
- 单片机入门基础班\跑馬燈 单片机入门基础班\跑馬燈-Introduction to basic single-chip single-chip entry-basic Marquee Marquee
serial
- 单片机模拟串口通讯 I/O口模拟232通讯程序 使用两种方式的C程序 占用定时器0-Analog single-chip serial communication I/O port 232 Analog communication procedures in two ways to use the C program occupied timer 0
lcd1602
- 用ICCAVR开发的基于ATMEGA16的程序。本程序是通过AVR写1602的驱动。-ICCAVR developed using procedures based on the ATMEGA16. This procedure is written through the AVR driver 1602.
wxo2_1
- 介绍了PIC的单片机程序如何实现制氧仪的研究,程序中有详细的注释.-Introduced the PIC microcontroller oxygen instrument procedures for how to achieve the study, procedures are detailed in the notes.
led
- pic单片机控制多个数码管显示，采用分时接通方法-pic microcontroller to control multiple digital tube display, using time-switched method
drive7219
- 数码管驱动芯片MAX7219驱动(C)，单片机MSP430。-Nixie tube driver chip MAX7219 drive (C), MCU MSP430.
Hedef2
- Veichle Routing with Time Windows Algorithm, Lingo Codes, 輘tanbul Technical University Engineering Management, Supply Chain Management, Logistics, Goal Programming Problem
infra_decode
- 红外遥控器的解码子程序，用51单片机实现-the decode of infraed remote control,using MCS51
CE_ImageLoadAndTransparentDraw
- WINCE6.0下加载图片文件（包括JPG、PNG等格式）到CBitmap，和CBitmap透明背景绘制的源码-WINCE6.0，load image to bitmap and transparent draw
OSC_Cry1
- 此例程说明如何配置外部振荡器驱动22.1184Mhz晶体及如何选择此外部振荡器作为系统时钟 同时使能丢失时钟检测器复位功能。 假定22.1184Mhz晶体连接在XTAL1和XTAL2之间-This routine shows how to configure an external crystal oscillator drive 22.1184Mhz and how to this external oscillator as the system clock while Enable