资源列表
isd4003C
- 可录放语音芯片ISD4003的放音驱动程序，是本人精心调试的结果，与大家分享-can chip ISD4003 voice recording and showing the audio driver, I was careful testing results share with you
eye1
- AT89C52单片机上运行的程序,文件名为eye1.c 功能：AT89C52单片机作为分站与上位机（PC机或工控机）通讯， 双方均有RS485接口 ，T1作波特率发生器, 波特率为1200， 与上位机通讯的主要流程为：中断接受上位机发来的地址 信息，看是否是给本站发来的，若是, 接受后续的15个字 节，然后发送43个字节。若不是, 则不予理睬。 配套上 位机程序为xsa2.c。
stopwatch
- 基于fpga的停表设计vudl编写，使用vhdl编写的.v文件。-the stopwatch based on fpga written with vhdl
Finit_state_machine_in_C
- C实现一个状态机,我做毕业设计，实现自组织网络，三个节点-Finit state machine implemented in C code
chepin
- 利用51单片机进行测频，分为测频与测周两种方案。10Hz到10KHz范围-Carried out using 51 single-chip frequency measurement, frequency measurement and the measurement is divided into the two-week program. Range of 10Hz to 10KHz
32-rip-adder
- A ripple carry adder allows you to add two 32-bit numbers
26204298SRAM-PINGPANG
- 一个用verilog写的简单的乒乓球程序，用来在VGA上显示小球和挡板-Using Verilog to write a simple table procedures, used in the VGA display of small ball and baffle
NRF_TO-HUMAN
- 基于arduino以及无线模块NRF24L01的无线监控程序 使用了人体红外探测模块检测-Based on the arduino as well as wireless module NRF24L01, wireless monitoring and control procedures using infrared detection module detects
16F-EXTERNAL--INT
- Code for External Interrupt
shift-register
- VerilogHDL语言实现的普通寄存器-VerilogHDL language common register
LCD16x2 Interfacing
- This source VHDL code is used for control LCD16x2 on FPGA
lcd
- This source is used to control LCD 16x2 on FPGA board