资源列表
display1980
- 中央空调恒温恒湿控制器c51源程序的显示子程序-central air-conditioning controller decoder source of constant display subroutine
T18b20
- 18B20 测温度的C程序代码,经过测试保证可用,注意调整延时时间
IC2
- 此段程序是针对IC2总线的应用,为8字节的收发系统.
X5045
- 看门狗关于x5045的源程序，是最新的5045；例程
1602
- 功能：从左至右，分2行滚动显示：“www.xjtu.edu.cn”和“WELCOME TO XJTU”
MCU_MeasureFrequency
- 单片机测频程序 采用测频法和测周法进行等精度测量频率，测频范围：20Hz到29kHz
em4095
- 125KHZ低频读卡器程序，射频芯片为EM4095，程序代码为读取ID程序。-125KHZ frequency reader program, the RF chip EM4095, read the ID code for the program.
pwm-linux
- linux下用2440产生一个pwm输出，linux学习必备-2440 to produce a pwm output under linux, the linux learning essential
linux-gpio
- Linux下的开发板中的驱动，程序很适合初学者-Driver in the Linux development board, the procedures are suitable for beginners
main
- NIOS 串口的主程序 通过NIOS接受发送PC端的数据-NIOS serial port of the main program to send the PC side of the data accepted by NIOS
dirital_clock_7
- verilog实现电子时钟模块，输入60Hz时钟信号和复位，输出时分秒，共6位，每位7段输出用于驱动-verilog electronic clock module, 60Hz input clock signal and reset, Minutes exportation, a total of six, each of the seven drivers for output
dirver2motor
- C51，位置检测，两个电机控制，变向等功能-C51, position detection, two motor control, the function becomes