资源列表
Simple_Verilog_Code_For_Beginner
- verilog code for beginner (adder, comparator, mux, or, and subtractor)
51-Serial-Communication-source
- 51单片机串口通信源程序，C语言，串口通信-51 Serial Communication source, C language, serial communication
main
- MSP430串口通信 /***************************************************** 程序功能：MCU不停向PC机发送数据,在屏幕上显示0~127对应 的ASCII字符 ------------------------------------------------------ 通信格式：N.8.1, 24-MSP430 serial communication /********************************
17c42
- PIC子程序，用于方便查找简单的子程序，不用浪费多余的时间-PIC subroutines
keyboard
- 基于stc51单片机开发试验板的第二份键盘程序。c代码-Based on the microcontroller development board test stc51 keyboard program. c code
d
- main函数中两个参数的用法 MSDN6.0中写道:argc is An integer specifying how many arguments are passed to the program from the command line. Because the program name is considered an argument, argc is at least 1.-main function uses two parameters MSDN6.0 wrote: arg
main
- 单片机P0.16低电平触发外部中断0通过按键控制-Microcontroller P0.16 low level triggered external interrupt 0 through key control
RUN-LED
- LED跑马灯，循环控制，不断显示，在飞思卡尔下-run LED,it runs all time in the type of control by the chipper of freescale
DMAC
- 该程序实现在ALTERA FPGA 上搭建NIOS系统，实现DMA 传输-The program built on the ALTERA FPGA NIOS system, DMA transfer
jishuxianshi
- 用VHDL语言，实现计数显示电路的设计。-Using VHDL language, counter display circuit design.
stopwatch
- 数码秒表设计:开发板上4键从左至右为S1-S4，上电后，开始时显示 0.0 ； 利用S1按键后启动计时；S2按键后停止计时；S3按键后计时归零；最大计时 为9.9秒。计时误差小于0.2秒，显示稳定。 晶振频率：11.0592MHz -Digital stopwatch design: 4 key development board left to right S1-S4, after power is displayed at the beginning of 0.0 S
8bit
- 基于51单片机的lcd 8位数据位控制代码-Based on 51 MCU LCD 8 bits of data control code