资源列表
软件红外线接收程序.c
- 软件红外线接收程序- Software infrared receive procedure
29c040_c
- 如AT040flash的的初始化，读操作，写操作，扇区擦除等-If the AT040flash initialization, read operation, write operation, sector erase, etc.
giveio
- driver for JTAG Flash writer
UART-for-Silabs-c8051f350
- uart program for silabs 350
51
- 51单片机会呼吸的灯 51单片机驱动 C语言-51 single 51 single light breathing drive C language
sdmrbeh
- This code implements the behavioral modelling of a Moore type sequence detector to detect the sequence 1010. The code is a quartus project file
SerialComunications
- 单片机串口通信keil—C语言程序 试 验 功 能: 通过单片机发送数据给PC机显示-SCM serial communication keil- C language program try inspection work can send data by MCU, for PC display
DCM_12M_1M
- xilinx下DCM输出12Mhz和1Mhz-Verilog DCM xilinx ISE
frequent
- FPGA等精度测频模块，实现任意频率的等精度测量-FPGA and other precision frequency measurement module, such as precision measurement of any frequency
aixunle
- 单片机的内容，实现定时器的设计，C8F8051F340固定延时，并且能够实现等的闪烁-SCM content, to achieve the design of the timer, C8F8051F340 fixed delay, such as blinking and can achieve
UART_MODULE
- 本程序是一个简单的232串口程序，采用VHDL语言编写，并已在3S500E上测试通过-This program is a simple 232 procedures, the use of VHDL language, and has been tested on the 3S500E
erase
- 这是用FPGA控制flash擦除代码，语言是verilog，flash型号是k9k4G08U0-It is used to control flash erase FPGA code, the language is verilog, flash model is k9k4G08U0