资源列表
music_based_on_C51
- 基于单片机c51的音乐彩灯程序，很适合初学者-music based on C51
Demo
- 使用T1作为定时器（定时时间为50毫秒），T0作为计数器（计数由电机测速电路产生的脉冲个数，每转4个脉冲），每1秒时间后，读出T0的值（读出后须将T0清0），将该值（速度值*4）显示到LED数码显示器上-The use of T1 as a timer (time of 50 ms from time to time), T0 as a counter (counting from the electrical pulse generated by gun circuit number, 4 p
1
- 弄电路图弄逼曙开工率显形立即jklda蝠a-塞住的嘴、‘nfggf
hongwaiyuanma
- 基于单片机定时器的数字钟-动态扫描. C元码-hongwaiyuanmachenxu
Floatsin_sub
- 基于51单片机的归一化正弦函数子程序，入口操作数在R0指向的单元，出口同为R0指向的单元-Based on MCU 51 Normalized sine subroutine
Decimaladdtionandsubtractioncounter
- 十进制加减计数器，用C51编写，用单片机实现加减计数-Decimal addition and subtraction counter, with the C51 preparation, counting addition and subtraction with MCU
EEPROM
- EEPROM与单片机的通信的程序，感觉很好，拿来与大家分享！-Communication with the microcontroller EEPROM process, feeling good, used to share with you!
HD7279
- 7279的详细开发资料程序，有详细说明，经过验证-discribe the 7279,tell you hwo to use it.
ceju
- 超声波测距C程序，适用于51单片机，亲自在Keil C 51软件环境下调试过。-Ultrasonic Distance C program for 51 single-chip, in person at the Keil C 51 lower tried the software environment.
UART
- Transmition and reception on UART Dspic 4013
1
- mega16 单片机 cvavr 使用2个LED数码管，设计一个60秒的倒计时显示器。（接通电源后，显示为60，然后每隔1秒减一显示）-mega16 SCM cvavr use two LED digital tube, to design a 60-second countdown display. (After power is displayed as 60, then every 1 second by a display)
dongji
- 基于lpc2131。lpc2132.lpc2138的舵机控制程序。-Based on lpc2131. lpc2132.lpc2138 steering gear control program.