资源列表
fifo数据缓冲器的vhdl源程序
- 编了个8*8位的fifo数据缓冲器的vhdl源程序，是经过quartusII4.2编译成功的程序。。希望能跟各位交流-Bianlegan 8 * 8 of the data buffer fifo VHDL source, after quartusII4.2 compiler successful procedures. . Hope you enjoy the exchanges
flash
- 通过NIOS环境用C语言对Flash进行读写操作，对初学者有很好的参考价值 -NIOS environment by using C language on the Flash read and write operations on the value of a good reference for beginners
ddpi_rx
- 描写处理器与FPGA之间的接口程序，使用verilog语言编写-Describes the interface between the processor and the FPGA program, using the verilog language
traffic
- 采用 EDA 技术，并应用目前广泛应用的VHDL 硬件电路描述语言，实现交通灯系统控制 器的设计。掌握使用VHDL 语言设计有限状态机的方法。-Using EDA, and applied widely applied to the VHDL language, hardware circuit to describe traffic control system Design. Master use VHDL language design method of finite state
sign_by_unsign_multiplication
- sign by unsign and sign by sign multiplication in verilog
full_add
- 全加器，可移植性很强，只需要变换一下里面的数字就能得到任意的全加器！-The counter, portability is very strong, only need to a change in the inside of the digital can get any counter!!!!!
rtl
- led and 7segment with verilog
sram_vhdl
- 基于vhdl的sram读写访问程序，经过前后仿真及板上实际测试-failed to translate
FM25
- fm256是一个铁存储器，适合于对数据的存储-Fm256 is an iron storage, suitable for data storage!!!!!!!
I2C
- 它是PIC单片机的一次关于I2C通讯的试验，它成功的完成了对I2C时序的编程，实现了I2C的通讯-It is a PIC microcontroller I2C communication test, it successfully completed the programming of I2C timing, I2C communication
i2c
- 这是一个用C写的I2C操作程序,对24C02进行操作程序-This is a keyboard scanner
CM_WADDR
- Complex multiplier with twiddle factor