资源列表
点对点串行通信
- 用于串口通信的源代码 用c编程的程序 希望对大家有用-for serial communication with the source code c programming procedures hope useful for all
KEY-AND-LED-DISPLAY
- 本程序是检测矩阵键盘，并且用数码管显示键值的。经过反复的测试证明程序稳定，可靠。
34
- 利用单片机和两个按键控制步进电机智能正反转-The use of microcontroller and two buttons control the stepper motor Intelligent positive inversion
main
- 嵌入式Linux下的U盘自动挂载程序，是一个守护进程。-U-disk embedded Linux automatically mount program is a daemon.
UART0
- 此程序是单片机C8051F020的UART0串口调试程序，经验证成功。-This program is the UART0 C8051F020 microcontroller serial debugger, proven successful.
traffic
- 交通灯的程序，是使用AT89C51单片机做的-Traffic light procedure is done using AT89C51 microcontroller
daobao
- 基于PCL-812PG采集卡的开关量通道，实现模拟流水线打包机工作过程的c代码。-PCL-812PG acquisition card based on the digital channel for analog line packer working process of the c code
zuoye3_1
- 四位LED显示程序，将一定单元的数值送到LED显示，包括延时-Four LED display program, the value will be sent to the LED display unit, including the delay
C
- 32位单片机通过I/O端口实现流水灯显示的程序-Water light display program 32 microcontroller I/O ports
jiaotongdengdekongzhichuxue
- 这是通过定时器中断来控制三种颜色灯的亮灭，它有两种模式，可以由键盘控制模式的转换-This is the timer interrupt to control the three colors of light, light off, it has two modes, the conversion from the keyboard control mode
void-Modify
- 主要是用于学校对学生的基本资料进行修改，当学生增加或减少、成绩打印错误时，它根据学生的学号提示来修改该学号所对应的学生资料。-Is mainly used for school students basic information modify, when students increase or decrease, grade printing errors, according to its students to revise the number corresponding to the
WifiDirectAutoAccepter
- wifi direct 免除确认按钮，基于Xposed框架结构-wifi direct remove confirm click，based on xposed framework