资源列表
rom
- 没事时抄写下来的，希望对更位想省事的朋友有点帮助，关于单片机的，我抄这个都快累的， 不知道现在有没有人先前抄好
SCA100T
- 倾角传感器SCA100T的单片机驱动程序，在M128上调试通过-Tilt Sensor SCA100T microcontroller driver debugging via the M128
M147
- 这是MAX147的汇编程序,功能：本程序主要是读出输入通道CH0(或CH1,CH2,到CH8)的模数转换值,转换值放在寄存器R6,R7中,R6放高位。MAX147芯片的8个通道可编程为单极性/双极性和差动/单端工作, 这里采用单端\单极性输入。MAX147有内部时钟和外部时钟两种工作模式,这里采用内部时钟模式-This is the MAX147 s assembler, function: This program is mainly read input channel CH0 (or C
cure-light
- 一个可以让灯，绕着心心转的程序，主要用来流水灯用的！-a program can make a heart ,it is very beautiful!!!do not miss...
led_1addto100
- 51单片机控制，在数码管上显示1~100的，间隔1秒.-This program is used to display the number from 1 to 100 on a nixie tube, adding 1 per second, which is controlled by 51 MCU.
motorspeed
- 采用单片机89C51控制直流电机运行，在运行过程中可以实时调节电机的转速，代码采用keil c编写-The 89C51 microcontroller to control the operation of the DC motor can adjust the motor speed in real time during operation, code written in keil c
ATs511
- 51单片机程序源码，在LED上实现字符8的循环移位显示程序-51 SCM procedures source, the LED to achieve the cycle of eight characters show translocation process
spi_rx-tx_prog
- spi reception and transmission.
ChannelDef
- 充分地利用枚举类型，定义数据采集通道对应关系，大大简化了C的程序设计。-Full use of enumeration types, the corresponding relationship between the definition of data acquisition channels, greatly simplifying the C programming.
inicodeR61509V
- 初始化代码R61509V,2.8寸TFT显示屏-Initialization code R61509V, 2.8-inch TFT display
UART
- 3． 利用例程中给出的函数完成以下实验编程： A. 波特率38400，8个数据位，1个停止位，奇校验，无硬件流控制与PC机通信； B. 通过PC机传送学号，如果为奇数请在PC机打印 “The num xxxxx is odd.”, 如果为偶数请在PC机打印 “The num xxxxx is even.” xxxxx 为学号。 -3. Given function to complete the following experimental programming routine:
UART_On_Atmega16
- UART implemented on ATMEGA16