资源列表
UART3
- 基于verilog语言编写的串口通信程序-verilog
GUI_RTC_20120202
- lpc2146嵌入式gui以及rtc时钟控制。-lpc2146 GUI_RTC
Mobile_Communication
- 关于通信技术的PPT,适合有一定硬件基础的同学，也适合给通信的初学者作为文献参考-A PPT for learning Advanced_Techniques_in_Mobile_Communication
mod_4
- this code for reliable power aware ASICs which i have done in lab..
nsp_1_10_01_06
- 德州仪器的EMAC外设开发包，配合NDK使用，应在CCS4.2版本以上使用。-Texas Instruments EMAC peripheral development kit, with the NDK should CCS4.2 or higher.
AC_Transducer_SVPWM
- 单相变频控制器源码，可实现单相电机的VF调速控制。-Single-phase inverter controller source code, enabling VF speed control of single-phase motor.
SD_SPI
- 读写SD卡的Verilog程序，希望对大家有用!-SD card reader Verilog program, I hope useful for everyone!
ass1_2_hamming
- Hamming codes are a class of binary linear codes. They can detect up to two simultaneous bit errors, and correct single-bit errors. In particular, a single-error-correcting and double error detecting variant commonly referred to SECDED.-a) Develop a
niosii-triple-speed-ethernet-4sgx230-qsys-141
- 利用nios在altera的cyclone4sgx平台上实现一个三态以太网控制器(Implementation of a three state Ethernet controller using Nios)
单片机
- 1.通过ADC0808转换器，将模拟信号转化成数字信号，可以通过电阻的调节来控制LED数码管转速的显示，且精度达到0.01。 2.通过示波器更方便、明了地显示电阻与电压的关系，结果如图所示。(1. through the ADC0808 converter, the analog signals are converted into digital signals, and the display of the LED digital tube speed can be controlled
ucos_driverlib_demo_v1.0
- 基于TMS280049C LAUNCHPAD的C2000的片载系统UCOS-II(UCOS-II depend on C2000 MPU)
dsp281x
- 这是dsp281x资料，通过这个资料学习dsp281x