资源列表
AU7_T108dl
- au7 + t108dl au7 + t108dl-au7+ t108dl au7+ t108dl au7+ t108dl
12345576
- 单片机开发的一个完整性，多功能控制系统，绝对原创。-The integrity of the development of a single-chip, multi-function control system, an absolute original.
LED-pwm-
- LED触摸调光台灯，本设计采用的为stc公司生产的stc12c2052ad单片机，晶振无要求，合适即可，由于触发问题，此次设计采用定时器0生成PWM信号，按键响应延时可自行修改，初学者的课程设计，需要的可以看看，正在努力学习中，不足之处还望指正~-LED touch dimmer lamp, this design uses for the company s stc12c2052ad stc microcontroller, crystal-free requirements, appropr
STM32-Step
- output certain number pwm to driver a step motor
avr-design-example1-(3)
- 这个是运用avr单片机编写各种小程序的实例与详细教程-Avr microcontroller this is to use a variety of small programs written examples and detailed tutorial
111111
- 模拟电路基础教程,详细介绍了模拟电子的基础知识-Analog circuits based tutorial introduces the basics of analog electronics
Led_burnflash
- 本源码为led闪烁实验 经本人测试 功能正常 -The source code for the flash experiments led by my test function was normal
uCOS_DEMO_LCD
- uCOS_DEMO_LCD金牛开发板LCD刷屏显示实验例程.-uCOS_DEMO_LCD Taurus development board LCD refresh experimental routines.
monidianziruanjian
- 择PCB板材必须在满足设计需求和可量产性及成本中间取得平衡点。设计需求包含电气和机构这两部分。通常在设计非常高速的PCB板子(大于GHz的频率)时这材质问题会比较重要。例如，现在常用的FR-4材质，在几个GHz的频率时的介质损(dielectric loss)会对信号衰减有很大的影响，可能就不合用。就电气而言，要注意介电常数(dielectric constant)和介质损在所设计的频率是否合用。-Optional PCB sheet must meet the design requireme
usb_drivers
- S3C2410X USB下载器的安装指南说明-S3C2410X USB downloader Installation Guide
Audio-Loopback_v3.3
- 音频输入与输出，McASP的设置和通讯，AIC23B设置音频数据的交换-Audio input and output, McASP settings and communication, AIC23B set exchange audio data
DDRsdram2
- 一个DDR2 的控制器源码，它是由LATTICE的编译器生成。-A DDR2 controller source code, which is generated by the compiler LATTICE.