资源列表
STM32_PID
- 基于STM32的PID控制程序,程序可用于大部分情况，虽然只有一部分(the pid control by stm32)
BMS SOC SOH
- In this paper, a typical BMS block diagram has been proposed using various functional blocks. The state of charge(SOC) estimation has been implemented using Coulomb counting and open circuit voltage methods thereby eliminating the limitation of the
AutomaticGuitarTuner
- 基于simulink嵌入式开发，开发板使用arduino UNO(arduino develop based on simulink)
ADC0832应用
- 基于AT89C51，采用LCD1602液晶显示0~5V模拟电压量。采用proteus仿真和KEIL4 C语言编程实现。(Based on AT89C51, the LCD1602 liquid crystal display 0~5V is used to simulate the voltage quantity. It is realized by Proteus simulation and KEIL4 C language programming.)
PIC32MM.X
- 实现SX1280的收发程序，模式可以自行设定，FLRC实测速率可以达到1Mbps(Achieve the SX1280 transceiver program, the mode can be set by itself, the measured speed of FLRC can reach 1Mbps)
STM32F103_AS5048A-master
- 使用stm32开发的as5048a的驱动程序。(The driver of as5048a developed by stm32.)
交通灯
- 1.设计一个十字路*通信号灯控制器，其要求如下： 设南北方向的红、黄、绿灯分别为r，y，g；东西方向的红、黄、绿灯分别为R，Y，G，满足图1 的工作流程并且可以并行工作：g（R）→r（G），黄灯用于提示绿灯变为红灯或者绿灯变为红灯。(1. Designing a traffic light controller for intersections, the requirements are as follows: Let the red, yellow and green lights in
Chinese_Calendar
- 一个单片机＋实时时钟芯片实现的万年历程序，包括源代码和原理图设计，以及一些相关资料。-a real-time clock chip to achieve the hefty almanac procedures, including source code and the schematic design, and some relevant information.
CC1110
- 基于cc1110无线射频的点对点通讯代码，实现串口透传功能-CC1110 wireless RF point-to-point communication based on the code, serial transmission function
SignalTap-II-instruction
- 对于学习FPGA的同学来说仿真是必不可少的流程 但是仿真的方法signal tap是必须掌握的-For students learning FPGA simulation is an essential process but the simulation method tap signal is a must
ess3890
- 影蝶机方案源代码。音视频信号处理及读盘软件处理。-failed to translate
51-MCU-based-on-experimental-(C-and-compilation).r
- 关于51单片机的基础实验（C+汇编），简单的基础实验，非常适合初学者-51 MCU based on experimental (C+ compilation), the simple basis of experiments, very suitable for beginners