资源列表
specs
- Projector Specification
test_01
- 来源于infineon的资料 用于产生SVPWM信号 以控制交流伺服电机 自己修改 亲测过-this program is used for generating the SVPWM signal to control AV servo motor
CC1110
- CC1110的基本发送/接收程序。包含串口，DMA，FLASH等模块的调用-The CC1110' s basic send/receive program. Including serial ports, DMA, FLASH module called
scitest
- 该SCI例程适用于三意F2812开发板，内涵.gel、cmd文件、csl头文件以及c代码-SCI program for F2812
IIR
- 这是关于TMS320F28335DSP的IIR滤波器的完整程序，调试通过的，实用性很强。-This is about the integrity of the IIR filter TMS320F28335DSP program, debug through, very practical.
08.VBT6-ADC
- VBT6的ADC实验，经本人测试-VBT6 the ADC experiment, as I test
LCD1335.rar
- 用于DSP28335的LED程序,能支持DSP强大的功能,LED program on basis of 28335
MCU_291
- 移植到GBA上的uCOS2.85操作系统和ZLGGUI用户图形界面-Ported to GBA uCOS2.85 on the operating system and graphical user interface ZLGGUI
74hc4017
- 实现的是扭环形十进制计数器，用verilog HDL 语言，在Actel公司提供的LiberoFPGA开发环境下实现，代码经过验证，可在ModelSim中仿真 -Ring is twisted to achieve a decimal counter, using verilog HDL language, Actel offers the LiberoFPGA development environment, the code is validated, the simulation in t
I2C-qtled
- 使用 2410 实验平台上 4x4 用户键盘，编写程序接收键盘中断。通过 IIC 总线读入键值，并将读到的键值发送到串口。-Experimental platform using the 2410 4x4 user keyboard, write a program to receive the keyboard interrupt. IIC bus read through the key, and read the key sent to the serial port.
ad9854fpga测试程序
- 基于fpga和ad9854的dds发生器，包含测试程序
DSP.Facts.and.Equipment
- DSP Facts and Equipment Reference was edited and published by SGC. The SGC DSP manual or SGC DSP guide or SGC DSP instruction provides