资源列表
TFT_0401
- 基于STM32的 模拟时序，瑞萨R61505 TFT驱动程序-R65105 TFT Drivers on STM32
dds
- 基于DDS的调频调相 通过改变频率控制字来控制 程序编译过 搭过硬件 可以实现-FM Based on DDS phase modulation by changing the frequency control word to control the program compiled the hardware can be achieved take-off
watch-dog
- XEP100：当用户程序“跑飞”，看门狗产生一个强制系统复位。为了阻止看门狗复位，用户程序 必须定期的复位COP计数器。通过向COPCTL寄存器中写入0x00可以关闭看门狗。单片机复位 后的默认状态看门狗是关闭的。设置COPCTL寄存器可以设置看门狗的延迟周期。在COPCTL 设置的周期时间内，向ARMCOP寄存器先后写入0x55和0xaa，将清除COP看门狗定时器，但 不会对寄存器内容造成影响。向ARMCOP中写入除了0x55和0xaa的任何值将导致系统的复位。-XEP100:
Programming-Specification
- 提供的是针对初级入门者使用单片机所需的编程规范-Provided is required for junior beginners to use microcontroller programming specification
verilog_ise_spatan3_clock
- verilog 时钟程序实例在ise下编译通过spatan3的芯片-Verilog clock procedures and ideally under the examples compiled by the chip spatan3
shumaguandongtaixianshi
- 实现开发板上8 个数码管动态显示0~7。通过这个实验，掌握采用Verilog HDL 语言编程实现7 段数码管显示译码器以及数码管动态扫描显示的方法。-Development board 8 digital tube dynamic display from 0 to 7. Through this experiment, master the 7-segment LED display decoder and digital tube dynamic scan display method
keil_arm
- Keil下ARM7的几个简单实例，方便初学者学习。 Protues软件方针通过!-Some examples of ARM7 Keil Projects, for beginners of embeded programming. Protues stimulation projects are providing for all of the examples.
DEC643_FLASH
- 合众达公司开发板tms320cdm643的flash例程-Triangle of company development board tms320cdm643 the flash routines
threemicrocontrollerprojects
- Contains three microcontroller projects which can be implemented using embedded c.
Picoblaze1
- This a software to synthesize a microcontroller in a FPGA
444
- 考虑调度计划和运行经济性的风电场储能容量优化计算-Consider scheduling plans and operating economy of the wind farm storage capacity optimization
Manual-of-keil-for-arm-
- Manual of keil for arm，介绍kei的使用方法，包括基本的配置、运行环境、与ADS的比较和移植。-Manual of the keil for arm, introduced kei use, including basic configuration, operating environment, ADS comparison and transplantation.