资源列表
fixed_pointDivider
- 本人编写的定点除法器,开发软件为XILINX的ISE6.2,通过PAR仿真.-I prepared for the sentinel division, the development of software for the ISE6.2 Xilinx, PAR through simulation.
PS2KEYBOARD
- 通过PS2键盘接口，实现简单的键盘到FPGA通信，将按键ASC码显示在LED上。-this is a design of PS2keyboard based on PS2 protocol, realizing the display of the ASC code of each key on the led.
SD-RW
- SD卡的读操作和写操作程序，实验已经通过，可以参考下-SD card read and write operating procedures, experiments have been through, you can refer to the following
2DS18B20
- 基于单片机和DS18B20的分布式多点温度检测系统的设计-DS18B20 based on single chip and multi-point temperature of the distributed detection system
EasyJTAGHmanual
- EasyJTAG-H manual, EasyJTAG-H manual,EasyJTAG-H manual
MC51_AVR_MCU_I2C-SPI-232-485-IO
- 各种串口接口屋里规格以及串口之间的相同不同点，串口接口协议-The same difference between a variety of serial interfaces room specifications and serial, serial interface protocol
DS1302
- 这个压缩文件是关于DS1302传感器的源代码，里面介绍了在编程时的一些问题，同时有源代码供大家使用-This compressed file is about the DS1302 sensor source code, which describes some of the problems in the programming, while the source code for everyone to use
vhdl
- 《数字信号处理的FPGA实现（第三版）》作者：U.Meyer-Baese 的配套源码，基于quartus9.0用VHDL编写，使用的cyclone ii。其中包含FIR IIR FFT等算法的实现，对学习图像处理很有帮助。- FPGA digital signal processing (third edition) Author: U.Meyer-Baese The matching source, based on quartus9.0 prepared using VHDL, t
adder4
- 这是一个用verilog编写的四位加法器，编程环境是xilinx ise10.1.-This is a written with the four adder verilog, programming environment is xilinx ise10.1.
PLC-FX20-code
- 三菱FX-20型PLC的实例代码，含变频器通信实例-Mitsubishi FX-20 type PLC code examples, including examples of the inverter communication
ucos
- ucos是一个小型的嵌入式实时系统，版本为2.9.1，其中我还讲开发环境也一同上传了，到时可以分开下载。步骤很清晰的-ucos is a realtime system ,and it very use for some import envirament.
TMS320x280x_ADC
- DSP的ADC原理，对软硬件AD采样精度有帮助。-DSP ADC principle, the hardware and software of AD sampling precision help.