资源列表
Triac-working-with-I2C-ADC-and-PWM
- 89S52 based project controls the triac using PWM to control the light intensity based on the light intensity.
pll
- 用VERILOG语言实现的数字锁相环P-VERILOG language with the digital phase-locked loop PLL
CVI-SCOPE
- 用开发板内核来实现FPGA开发板通过USB端口通信程序-Development board with FPGA development board to implement the kernel through the USB port communication program
Codec
- 用来控制codec器件工作 程序的主要内容是： 1、配置I2C总线控制codec的工作模式。 2、配置McBSP1，接收与发送codec的数据。-Procedures used to control the codec device main contents are: 1, I2C bus control the codec configuration mode. 2, configuration McBSP1, data reception and transmission co
ColorGray_ImageProcessing_in_C
- This program is used to read and display a color image and a grayscale image. The imput images should be of size 320x240, The color image should be named inputRGB and grayscale image should be named inputGray . The images should be of BMP type. the o
RS232
- RS232的一个verilog程序。
rs232
- fpga的串口读写程序，经硬件测试成功，波特率9600.可以改变分频值适应不同的时钟和波特率-fpga serial read and write procedures, by the hardware to test the success of 9600 baud rate. frequency value can be changed to adapt to a different clock and baud rate
USB-Drive
- 基于CY7C68013A的USB固件配置,可用于实际工程设计.采用的是外接FIFO设计.-USB firmware configuration based on CY7C68013A,Can be used for practical engineering design. The use of external FIFO design.
UART
- 芯片LPC1768，实现UART，串口收发程序。-Chip LPC1768, achieve UART, serial transceiver procedures.
an490
- Altera官方网站提供的MAXII系列CPLD做电平转换的应用文档，非常实用的。-Official website of the MAXII Altera CPLD family to do the application-level document conversion, very practical.
ABAQUS3Dcrack
- abaqus3D裂纹分析，PPT中是网格划分和边界处理，视频中为效果-abaqus3D crack analysis, PPT is mesh and boundary treatment, for the effect of video
power
- 是一本设计开关电源的好资料，开关电源各部分电路详解，详细介绍开关电源的组成原理。-Switching power supply is a good information design, switching power supply circuit Detailed parts, detailing the composition of the principle of switching power supply.