资源列表
ucos51
- ucosII for 51study3.1
ICC_canself=m128
- 基于avr单片机atmega128的CAN总线通信的自收发程序，采用sja1000+82C50模块，有参考原理图，程序在自己的项目板上通过，欢迎下载-Avr microcontroller atmega128 CAN bus communication transceiver program+82 sja1000 of C50 module, a reference schematic diagram, board through the program in their own project
PID_motor
- 本源代码是基于单片机的PID电机调速，代码包含详细注释。包内包含仿真图，安装proteus可直接仿真。单片机采用51系列，驱动包含LM298，显示驱动为1602.-The source code is based microcontroller PID motor speed control code contains detailed notes. The package includes simulation the Figure, install proteus simulation di
vgaverilog
- 本程序实现了基于FPGA/CPLD的VGA显示设计，简单易懂，可以输出8种颜色，即3位RGB颜色，共8种组合。连接FPGA的VGA口和液晶等显示器即可观察实验现象。-This procedure implemented based on FPGA/CPLD' s VGA display design, easy to understand, you can output 8 colors, the three RGB colors, a total of 8 combinations. FPGA
CY8c21434-ButtonLED
- Cypess CY8C21434 电容式触摸按键代码。 提供独立背光LED。 提供直观的代码, 8个触摸按键, 9个LED灯. 触摸芯片为CY8C21434 编译器PSoC Designer V4.4 按如下顺序配置 Cypress 芯片一般不会有问题. 1. 配置MCU 2. 配置EzI2Cs 3. 配置CSD 4. 配置其它, 如Timer等 5. 配置LED灯 配置完成后可以浏览一下引脚分配情况, 被配置的引脚都应该有具体的名称,
7
- 讲述PID控制的数学实现方法和数学推导，大家可以参考-PID control about the realization of mathematics and mathematical derivation, we can refer to
STM32DS18B20
- STM32系列单片机的DS18B20示例程序，使用C写的，喜欢的话赞一个-STM32 series SCM DS18B20 sample program, written using C, like a
matrix-optimize
- 这是dsp实验中用汇编语言编的矩阵相乘优化，包括4种优化方法，最终时钟周期400多个-This is the dsp series of experiments using assembly language to optimize matrix multiplication, including four kinds of optimization methods, the final clock cycle 400
video_preview1
- DM6347 video passtrue
MSP430
- MSP430系列单片机 是c语言原码，介绍430常用C程序
ucos51
- UCOS系统移植到51单片机上的程序，程序调试通过，直接运行-UCOS System Migration to 51 programs on the microcontroller
NRF24L01
- NRF无线模块的程序，使用IAR编写，调试两周以上，保证可用，只需要更改参数即可设置接收或发送，msp430上的程序-The NRF wireless module program, use the IAR to write, debug more than two weeks, guarantee available, you just need to change the parameter Settings to receive or send