资源列表
SCM-power-off-memory-function
- 利用24c08通电后 数码管从00开始计数 每过1秒加1，关闭电源后继续断电时的数值计数-The numerical count of digital control using 24c08 energized from 00 starts counting every 1 second plus 1, turn off the power to continue after power failure
Free-pendulum-control
- 基于STM32的自由摆控制总程序，这是2011年全国电子设计大赛我们自己设计的控制程序。-STM32 free pendulum control based on total program, which is the control program in 2011 the National Electronic Design Contest of our own design.
Ultrasonic-ranging-1602LCD-display
- 基于51单片机做的超声波测距，使用1602LCD显示-Based on 51 single-chip Ultrasonic Ranging 1602LCD display
ADC_3Channal
- Actel FPGA 3通道同时采样程序-Actel FPGA 3 Channel Sample Program
Based-on-a-DS1302-clock
- 基于51单片机使用最为常见的DS1302芯片做的时钟-Do use the most common DS1302 chip based on 51 MCU clock
eetop.cn_vgachar
- 对于初学者来说，FPGA的VGA显示，非常的基础，本文就介绍了，其基本用法。-For starters, the FPGA' s VGA display, the very basis of this paper, the basic usage.
10505580475060
- 本文档介绍了verilog的FPGA的VGA显示。希望对大家有帮助！-This document describes the verilog FPGA-VGA display. Hope everyone!
SDRSDRAM
- 为了使大家更好的了解sdram，本文档在sdram文档的基础上加入了，部分说明文献！希望对大家有帮助！-This document in order to better understand sdram joined the in sdram document based on section describes literature! Hope everyone!
Sdram_Control_4Port
- 文档介绍了SDRAM控制器，带有四个fifo,希望对初学者有一定的帮助。-The document describes the SDRAM controller with four fifo some help for beginners.
Centroid
- 质心定位算法源码，分三种情况考虑，只有锚节点，被定位到的未知节点也作为锚节点，有邻居锚节点的未知节点只利用邻居锚节点进行定位，没有邻居锚节点的未知节点才利用已经定位了的邻居未知节点进行定位。 -Centroid localization algorithm source，Three cases to consider.Only the anchor nodes,unknown nodes to be positioned as anchor nodes,neighbor anchor nod
DDRSDRAMverilog
- 本文介绍了sdram控制器的。本文附上了介绍文档，具有详细的说明。-This article describes the sdram controller. The attached introductory document, a detailed descr iption.
xunji
- 循迹小车详细资料电路图、程序、仿真及编程-The tracking car details schematics, procedures, simulation, and programming