资源列表
K1-K4-packet-control-LED
- 每次按下 K1 时递增点亮一只 LED，全亮时再次按下则再次循环开始， K2 按下后点亮上面 4 只 LED，K3 按下后点亮下面 4 只 LED，K4 按下后关闭所有 LED -Each press K1 increments lit a LED full brightness when pressed again, the cycle begins again after 4 LED lit above press K2, K3 Press lit following four LE
aaaa
- 运用74LS154和74HC595实现16*16点阵 优点节省端口资源，给大家共分享-Use to 74LS154 and 74HC595 achieve the 16* 16 dot matrix advantage of saving port resources for everyone to share a
i2c_int_ma
- USCIB0的I2C模式主机程序。在启动主机程序前先启动从机程序，然后再启动主机程序,主机连续发送100个数据,当发完后在最后一个字节后加入停止位。-USCIB0 I2C mode host program. Started before you start the host program from the computer program, and then start the host program, the host continues to send 100 data, when t
TA_1
- MSP430单片机定时器A的操作.定时器A的中断的应用。定时器A的比较模式应用。-timerA_operation.Telling how to use timerA interrupt.
TM1640_displayer
- TM1640显示程序能用，简洁。看过之后绝对不会后悔呀！-TM1640 display program can be used, concise.After reading absolutely will not regret it!
TempDataLogger
- Temperature data logger java source code (linux and windows 32,64 bit) -Temperature data logger java source code (linux and windows 32,64 bit)
SPI
- arm单片机的SPI口开发程序与说明，方便从事这方面的开发者易于上手。-arm microcontroller SPI port development program with instructions to facilitate developers engaged in this area is easy to use.
UART
- arm单片机的串口开发程序与说明，方便从事这方面的开发者易于上手。-arm microcontroller the serial development program with instructions to facilitate developers engaged in this area is easy to use.
lcd.ucf
- the lcd ucf file in xilinx ise
test
- the carry save adder program in verilog
reading_dna
- dna driver verilog code
chuankou
- 串口通讯，基于51单片机，新手自己编写程序，已经运行，无错误，希望借鉴-Serial communication based on 51 MCU, novice program has been running, error-free and hopes to learn from