资源列表
JDJ_13
- 数据采集及控制角度,用于交流伺服电机控制-Data acquisition and control perspective
EP_Interrupts
- 描述：SoEZ-USB2.0开发板端点中断实验(CY7C68013A)-bulk loopback firmware based on the firmware frameworks.
u-boot
- linux2.6内核下，可以移植到mimi2440开发板上运行，支持nand flash，yaffs。-linux2.6 kernel can be ported to mimi2440 development board to run, support nand flash, yaffs.
NRF905
- 射频芯片NRF905发送及接收程序，对在射频识别技术方面发展起了重要的作用。-Send and receive radio frequency chip NRF905 procedures, the development of radio frequency identification technology has played an important role.
Bulkext
- 这是51单片机批量端点间和外部RAM环路测试的Ｃ程序-bulkext is FX2 bulk loopback firmware. It loops back EP2OUT-> EP6IN and EP4OUT-> EP8IN
MSP430
- 16 位单片机 网上很难找的资料 找了好几天才找到的-very good
extr_intr
- 描述：外部中断控制SoEZ-USB2.0开发板LED(CY7C68013A)-The purpose of this example is to demonstrate that the functioning of External interrupts (INT0, INT1, INT4, INT5 and INT6) and how toset them up.
cydesc
- 描述：这是一个读取插入设备的设备描述符等的Ｃ程序-a simple console based application to demonstrate access to the Cypress Generic USB Driver via the CyApi class library. this example displays the device descr iptors for all devices bound to the Cypress driver.
dev_io
- 跑马灯－－本程序的目的是演示如何使用端口的GPIO方式-The purpose of this software is to demonstrate how to use the buttons and LED on the EZ-USB developer s kit.
mimasuo
- 基于at89c51单片机，利用8279芯片实现密码锁控制。它可以重新设置密码，三次输入错误密码，则键盘锁定。-At89c51 based MCU, using 8279 chip lock control. It can reset your password, enter the wrong password three times, the keypad is locked.
sd2068_430
- 这是一个实时时钟芯片的430单片机的C语言程序设例-This is a real-time clock chip microcontroller 430 cases of C-language program designed
SD2068Amarket1.4
- SD2068 是一种具有标准IIC 接口的实时时钟芯片,CPU 可使用该接口通过5 位地址寻址来读写片内32 字节寄存器的数据(包括时间寄存器、报警寄存器、控制寄存器、通用SRAM 寄存器)。-SD2068 is a standard IIC interface with real-time clock chip, CPU can use the interface addressing the 5-bit address to read and write on-chip 32-byte re